UPG2214TK Datasheet, PDF (4/11 Pages) List of Unclassifed Manufacturers – NEC1/2W LOW VOLTAGE L, S-BAND SPDT SWITCH

UPG2214TK
ELECTRICAL CHARACTERISTICS
(TA = +25°C, Vcont (H) = 1.8, Vcont (L) = 0 V, DC blocking capacitors value = 100 pF, unless otherwise specified)
PARAMETER
Insertion Loss 6
Insertion Loss 7
Insertion Loss 8
Insertion Loss 9
Insertion Loss 10
Isolation 6
Isolation 7
Isolation 8
Isolation 9
Input Return Loss 3
Output Return Loss 3
0.1 dB Loss Compression
Input Power ^{Note 2}
1 dB Loss Compression
Input Power ^{Note 3}
Switch Control Current
SYMBOL
Lins6
Lins7
Lins8
Lins9
Lins10
ISL6
ISL7
ISL8
ISL9
RLin3
RLout3
Pin (0.1 dB)
Pin (1 dB)
TEST CONDITIONS
f = 0.05 to 0.5 GHz ^{Note 1}
f = 0.5 to 1.0 GHz
f = 1.0 to 2.0 GHz
f = 2.0 to 2.5 GHz
f = 2.5 to 3.0 GHz
f = 0.05 to 0.5 GHz ^{Note 1}
f = 0.5 to 2.0 GHz
f = 2.0 to 2.5 GHz
f = 2.5 to 3.0 GHz
f = 0.05 to 3.0 GHz ^{Note 1}
f = 0.05 to 3.0 GHz ^{Note 1}
f = 2.0/2.5 GHz
f = 0.5 to 3.0 GHz
f = 0.5 to 3.0 GHz
Icont
MIN.
−
−
−
−
−
27
23
21
20
15
15
+14.0
−
−
TYP.
0.25
0.25
0.30
0.35
0.35
30
27
25
24
20
20
+17.0
+17.0
+20.0
MAX.
0.50
0.50
0.55
0.60
0.65
−
−
−
−
−
−
−
−
−
−
4
20
Switch Control Speed
tSW
50% CTL to 90/10% RF
−
20
200
UNIT
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dBm
dBm
μA
ns
Notes 1. DC blocking capacitors = 1,000 pF at f = 0.05 to 0.5 GHz
2. Pin (0.1 dB) is the measured input power level when the insertion loss increases 0.1 dB more than that of linear range.
3. Pin (1 dB) is the measured input power level when the insertion loss increases 1 dB more than that of linear range.
Caution It is necessary to use DC blocking capacitors with this device.
The value of DC blocking capacitors should be chosen to accommodate the frequency of operation, bandwidth,
switching speed and the condition with the actual board of your system. The range of recommended
DC blocking capacitor value is less than 100 pF for frequencies above 0.5 GHz, and 1,000 pF for frequencies
below 0.5 GHz.