TH8080 Datasheet, PDF (4/12 Pages) Melexis Microelectronic Systems – SoloLIN Transceiver

TH8080
Single LIN Transceiver
Electrical Specification
All voltages are referenced to ground (GND). Positive
currents flow into the IC. The absolute maximum ratings
given in the table below are limiting values that do not
lead to a permanent damage of the device but exceeding
Operating Conditions
Parameter
Battery voltage
Supply voltage
Operating ambient temperature
Junction temperature ^[1]
any of these limits may do so. Long term exposure to lim-
iting values may affect the reliability of the device. Reli-
able operation of the TH8080 is only specified within the
limits shown in ”Operating conditions”.
Symbol
V_S
V_CC
T_A
T_Jc
Min
6
4.5
-40
Max
20
5.5
+125
+150
Unit
V
V
°C
°C
Absolute Maximum Ratings
Parameter
Symbol Conditions
Batterry Supply Voltage
V_S
Supply Voltage
V_CC
Short-term supply voltage
Transient supply voltage
Transient supply voltage
V_S.ld
V_S.tr1
V_S.tr2
Load dump; t<500ms
ISO 7637/1 pulse 1^[1]
ISO 7637/1 pulses 2^[1]
Transient supply voltage
V_S.tr3 ISO 7637/1 pulses 3A, 3B
BUS voltage
Transient bus voltage
Transient bus voltage
Transient bus voltage
V_BUS
V_BUS.tr1 ISO 7637/1 pulse 1 ^[2]
V_BUS.tr2 ISO 7637/1 pulses 2 ^[2]
V_BUS.tr3 ISO 7637/1 pulses 3A, 3B ^[2]
DC voltage on pins TxD, RxD
V_DC
ESD capability of pin BUS
ESD_BUSHB
Human body model, equivalent
to discharge 100pF with 1.5kΩ
ESD capability of any other pins
ESD_HB
Human body model, equivalent
to discharge 100pF with 1.5kΩ
Maximum latch – up free current at any Pin I_LATCH
Maximum power dissipation
P_tot At T_amb = +125 °C
Thermal impedance
Storage temperature
Junction temperature
Θ_JA in free air
T_stg
T_vj
Min.
-0.3
-0.3
-150
-150
-40
-150
-150
-0.3
-4
-2
-500
-55
-40
Max. Unit
+27
V
+7
V
+40
V
V
+100 V
+150 V
+40
V
V
+100 V
+150 V
+7
V
+4
kV
+2
kV
+500 mA
197 mW
152 K/W
+150 °C
+150 °C
______________________________
[1] _{ISO 7637 test pulses are applied to VS via a reverse polarity diode and >1uF blocking capacitor .}
[2] _{ISO 7637 test pulses are applied to BUS via a coupling capacitance of 1 nF.}
Target Data Sheet Rev 1.0 Nov. 2000
Page 4
www.melexis.com