SPT9110 Datasheet, PDF (4/11 Pages) List of Unclassifed Manufacturers – 100 MSPS SINGLE-TO-DIFFERENTIAL TRACK-AND-HOLD

ELECTRICAL SPECIFICATIONS
AV_CC = +5.0 V, AGND = 0.0 V, R_Load = 1 kΩ and 10 pF, V_IN = 2.0 Vp-p, Internal Reference, unless otherwise specified.
PARAMETERS
TEST
CONDITIONS
TEST
LEVEL
SPT9110
MIN
TYP
Hold-to-Track Switching⁸
Acquisition Time to 0.1%
1 V Output Step
Acquisition Time to 0.025%
1 V Output Step
Power Supplies
Supply Voltage
Supply Current
Single Ended Output Mode⁹
Differential Output Mode
Power Dissipation
Single Ended Output Mode⁹
Differential Output Mode
Power Supply Rejection Ratio
Single-Ended Output
8. Measured at the hold capacitor.
9. Inverter powered down.
+25 °C
+25 °C
+25 °C
∆V_CC = 0.5 V_P-P
V
3.5
V
4.0
IV
4.75
5
I
15
I
24
I
75
I
120
V
44
MAX UNITS
ns
ns
5.25 V
20 mA
30 mA
100 mW
150 mW
dB
TEST LEVEL CODES
All electrical characteristics are subject to the
following conditions: All parameters having min/
max specifications are guaranteed. The Test
Level column indicates the specific device test-
ing actually performed during production and
Quality Assurance inspection. Any blank sec-
tion in the data column indicates that the speci-
fication is not tested at the specified condition.
TEST LEVEL
I
II
III
IV
V
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at T_A = +25 °C, and sample
tested at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design
and characterization data.
Parameter is a typical value for information purposes
only.
100% production tested at T_A = +25 °C. Parameter is
guaranteed over specified temperature range.
SPT
4
SPT9110
11/12/98