SM5430 Datasheet, PDF (4/4 Pages) List of Unclassifed Manufacturers – Low Cost Packaged Pressure Sensors

SM5430/SM5470
B- Horizontal Barb Configuration
7.52±0.13
10.31±0.20
19.60±0.25
10.26±0.25
1.27±0.04 [TYP]
0.41±0.08
16PL
5.00±0.08
0.84±0.10
5.54±0.25
0.25±0.02
3.00±0.08
Ø1.10
3.00±0.08
1
DIFFERENTIAL TYPE
4°+-03°°
3.00±0.08
5.54±0.25
NOTE:
1) ALL THE DIMENSIONS ARE IN MM
2) GAUGE/ABSOLUTE TYPE DIMENSIONS
ARE SAME AS DIFFERENTIAL TYPE
EXCEPT GAUGE/ABSOLUTE TYPE HAS
ONE SIDE PORT
1
GAUGE / ABSOLUTE TYPE
C- Vertical Barb Configuration
10.26±0.25
1.27±0.04 [TYP]
0.41±0.08
16PL
0.84±0.10
5.54±0.25
0.25±0.02
3.00±0.08
7.52±0.13
10.31±0.20
PIN 1 MARKING
1
5.50
2XØ3.00
2XØ2.21
2XØ1.24
4°+-03°°
3.00±0.08
DIFFERENTIAL TYPE
1
10.39±0.25
NOTE:
1) ALL THE DIMENSIONS ARE IN MM
2) GAUGE/ABSOLUTE TYPE DIMENSIONS
ARE SAME AS DIFFERENTIAL TYPE
EXCEPT GAUGE/ ABSOLUTE TYPE HAS
ONE VERTICAL PORT
GAUGE / ABSOLUTE TYPE
Dimensions (in millimeters) -- SM5430/SM5470
Notice:
Silicon Microstructures, Inc. reserves the right to make changes to the product contained in this publication. Silicon Microstructures, Inc. assumes no
responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the
circuits are free of patent infringement. While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies.
Silicon Microstructures, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can
reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such
applications
Rev 1.3 07_06
 2004-2006
Silicon Microstructures, Inc. ♦ 1701 McCarthy Blvd. ♦ Milpitas, CA 95035 USA
Tel: [phone] ♦ Fax: [phone] ♦ [e-mail] ♦ www.si-micro.com