KAI-1010 Datasheet, PDF (26/37 Pages) List of Unclassifed Manufacturers – Image Sensor

IMAGE SENSOR SOLUTIONS
Image Specifications
All the following values were derived using nominal operating conditions using the recommended timing. Unless otherwise
stated, readout time = 140ms, integration time = 140ms and sensor temperature = 40^oC. Correlated double sampling of the
output is assumed and recommended. Many units are expressed in electrons, to convert to voltage, multiply by the amplifier
sensitivity.
Defects are excluded from the following tests and the signal output is referenced to the dark pixels at the end of each line
unless otherwise specified.
Electro-Optical for KAI-1011CM
SYMBOL
FF
E_sat
QEr
QEg
QEb
Rgs
PRNU
PRNL
PARAMETER
Optical Fill Factor
Saturation Exposure
Red Peak Quantum Efficiency λ = 620nm
Green Peak Quantum Efficiency λ = 530nm
Blue Peak Quantum Efficiency λ = 470nm
Green Photoresponse Shading
Photoresponse Non-uniformity
Photoresponse Non-linearity
Amplifier Sensitivity
MIN.
NOM.
55.0
0.046
25
28
34
6
15.0
5.0
11.5
MAX.
UNITS
%
µJ/cm²
%
%
%
%
%pp
%
µV/e-
Table 6 Electro-Optical Image Specifications KAI-1011CM
Notes:
1. For λ = 530nm wavelength, and Vsat = 350mV.
2. Refer to typical values from Figure 19 Nominal KAI 1011CM Spectral Response.
3. Under uniform illumination with output signal equal to 280 mV.
4. This is the global variation in chip output for green pixels across the entire chip.
5. It is recommended to use low pass filter with λ_cut-off at ~ 680nm for high performance.
6. Per color. Units: % Peak to Peak. A 200 by 200 sub ROI is used.
NOTES
1
2
2
2
4
3, 6
26
KAI-1010/1011 Rev 8 • www.kodak.com/go/imagers 585-722-4385 [e-mail]