M170EG01VA Datasheet, PDF (24/26 Pages) List of Unclassifed Manufacturers – 17.0” SXGA Color TFT-LCD

Product Specification
AU OPTRONICS CORPORATION
M170EG01 VA
8. Reliability Test
Environment test conditions are listed as following table.
Items
Required Condition
Temperature Humidity Bias (THB) Ta= 50 , 80%RH, 300hours
High Temperature Operation (HTO) Ta= 50 , 50%RH, 300hours
Low Temperature Operation (LTO) Ta= 0 , 300hours
High Temperature Storage (HTS) Ta= 60 , 300hours
Low Temperature Storage (LTS) Ta= -20 , 300hours
Note
Vibration Test
(Non-operation)
Acceleration: 1.5 G
Wave: Random
Frequency: 10 - 200 - 10 Hz
Sweep: 30 Minutes each Axis (X, Y, Z)
Shock Test
(Non-operation)
Acceleration: 50 G
Wave: Half-sine
Active Time: 20 ms
Direction: X, Y, Z (one time for each Axis)
Drop Test
Height: 60 cm, package test
Thermal Shock Test (TST)
-20 /30min, 60 /30min, 100 cycles
1
On/Off Test
On/10sec, Off/10sec, 30,000 cycles
Contact Discharge: ± 8KV, 150pF(330Ω ) 1sec,
8 points, 25 times/ point.
ESD (ElectroStatic Discharge)
2
Air Discharge: ± 15KV, 150pF(330Ω ) 1sec
8 points, 25 times/ point.
Altitude Test
Operation:10,000 ft
Non-Operation:30,000 ft
Note 1: The TFT-LCD module will not sustain damage after being subjected to 100 cycles of rapid
temperature change. A cycle of rapid temperature change consists of varying the temperature from
-2 to 6 , and back again. Power is not applied during the test. After temperature cycling, the
unit is placed in normal room ambient for at least 4 hours before power on.
Note 2: According to EN61000-4-2 , ESD class B: Some performance degradation allowed. No data lost.
Self-recoverable. No hardware failures.
document version 0.1
24/26