A1PCA000A103 Datasheet, PDF (22/23 Pages) List of Unclassifed Manufacturers – The A01 and A02 series offer ranges of:pushbutton switches, illuminated or not

A02 series
Industrial controls
Installation
Modular construction / panel mounting
EMERGENCY
STOP
ROTARY
LEVERS SWITCHES
KEYLOCK
SWITCHES
PUSHBUTTONS & INDICATORS
SCREEN
LEGEND
REFLECTOR
LOCATING
SLOT
BULB
POLARISING
DOT
PANEL
SEAL
FIXING
NUT
OPERATOR
ADAPTOR BLOCK
SWITCH BLOCK
PANEL CUT-OUT
Round & square operators
Ø22.00 0.00/+0.50
(Ø.82626.0D0IA_{0.0.00/0+00/.+5.0019})
(.866 DIA .000/+.019)
13.00
1(3.5.0101)
(.511)
Rectangular operators
29.50 0.00/+0.50
2(91.5.1061
.000/+.019
0.00/+0.50
)
(1.161 .000/+.019 )
END CAP
PANEL CLAMP
FIXING SCREW
Max. panel thickness : 8 mm (.315)
PANEL MOUNTING ASSEMBLY
• Drill/punch hole in panel as shaped above.
• Assemble front operator through hole and :
a/ Round & square types : tighten nut to a maximum
torque of 0,8Nm using tool No 30-0001. Snap on
adaptor block
b/ Rectangular types : tighten two panel fixing screws in
front to a maximum torque of 0,06Nm.
• Wire chosen switch block as required and snap onto
front operator.
• Snap end cap onto switch block.
• Fit bulb if required using tool No 30-0002.
• Snap screen onto reflector assembly with legend in
between if required ans snap into front operator TAKING
CARE TO LINE UP THE LOCATING SLOT WITH THE
POLARISING DOT, and not to damage the seal.
TO REMOVE BULB
Remove reflector/screen assembly. Use the bulb extractor
30-0002 to remove the bulb.
TO REMOVE SWITCH BLOCK
Lever out latches using small screwdriver taking care not to
overbend, and pull off the block from the front operator.
A02 Accessories
Part No : 14-0005
G
End cap terminal guard offering unique terminal protection.
APEM
6.35 mm push on tab terminals.
Specify “SP” to the end of the switchblock and operator P/N.
Example : A02503SP.
www.apem.com
G-23