RYC8220-2P Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – RYC8220-2P

Tyco/Electronics
Raychem Circuit Protection
308 Constitution Drive
Menlo Park, CA 94025-1164
Phone: [phone]
Fax: [phone]
PolySwitch®
Power Switch
Devices
PRODUCT: RYC8220-2P
DOCUMENT: SCD 24679
PCN: 403629-000
REV LETTER: B
REV DATE: AUGUST 2, 2001
PAGE NO.: 2 OF 2
ELECTRICAL CHARACTERISTICS - NOTES
Note 1. Exceeding the absolute maximum rating may damage the device.
Note 2. Devices are ESD sensitive. Handling precautions recommended.
Note 3. The device is not designed to function outside its operating rating.
Note 4. Off is <0.8V and on is >2.4V for the RYC8220-1 and RYC8220-3. Off is >2.4V and on is <0.8V for the RYC8220-2 and RYC8220-4. The enable
input has approximately 200mV of hysteresis. Pull-down/Pull-up resistors are on chip for “-1” and “-2” configurations.
Note 5. Pull-up resistors are on chip.
Note 6. No error flag out delay on UVLO, OVLO and thermal shut down.
PIN CONFIGURATION:
ENA 1
FLGA ₂
FLGB 3
8 _OUTA
7
IN
6 GND
DEVICE MARKING:
8220
- 2P
Raychem Logo
Part ID1
Part ID2
Lot ID
ENB 4
5 OUTB
PIN DESCRIPTIONS:
Pin Number
1, 4
Pin Name
EN
2, 3
6
7
5 and 8
FLG
GND
IN
OUT
Pin Function
Enable (Input): Logic-compatible enables input. High input > 2.4V typical.
Low input <0.8V typical (-1, -3 active high, -2, -4 active low). Do not float.
Fault Flag (Output): Active-low open-drain output. Indicates overcurrent, UVLO, OVLO and thermal shutdown.
Ground: Supply return
Supply Input: Output MOSFET drain. Also supplies IC’s internal circuitry. Connect to positive supply.
Switch Output: Output MOSFET source. Typically connect to switched side of load.
MECHANICAL DIMENSIONS:
DIMENSION
A
A1
B
B1
C
D
F
G
H
J
L
M
MM
MM
MIN
MAX
3.05
3.81
0.38
0.89
9.40
10.16
7.62 BSC
6.10
6.60
1.14
3.17
2.29
0.38
7.62
7.37
0.20
1.65
3.81
2.80
0.58
10.92
7.87
0.38
IN
IN
MIN
MAX
0.120 0.150
0.015 0.035
0.370 0.400
0.300 BSC
0.240 0.260
0.045
0.125
0.090
0.015
0.300
0.290
0.008
0.065
0.150
0.110
0.023
0.430
0.310
0.015
DIP-8 PACKAGE NOTES:
1. Dimensions and tolerance per ANSI Y14.5M-1982.
2. Dimensions A, B, and C are datums.
3. Controlling dimensions: Inches
4. Dimensions B and C do not include mold flash. Mold flash shall not exceed 0.10 inch [0.25mm] per side.