QEB125 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – SINGLE OUTPUT

Model
Number
Input
Range
Output
Voltage
Output
Current
Eff ⁽⁶⁾
(%)
Load
regulation
QEB125-48S1P8
36 – 75 VDC
1.8 VDC
35A
84
5.4mV
QEB125-48S2P5
36 – 75 VDC
2.5 VDC
35A
86
7.5mV
QEB125-48S3P3
36 – 75 VDC
3.3 VDC
30A
88
10mV
QEB125-48S05
36 – 75 VDC
5 VDC
25A
90
15mV
Note
1. Maximum output deviation is 10% inclusive of trim. If remote sense is not being used, the +V sense should be connected to its corresponding
+OUTPUT and likewise the –sense should be connected to its corresponding –OUTPUT.
2. An external filter capacitor is required for normal operation. The capacitor should be capable of handing 1A ripple current for 48V models. Power mate
suggest: Nippon chemi-con KMF series, 220 F/100V, ESR 90m .
3. The negative / positive logic and pin length are optional ( see table ). The pin voltage is referenced to negative input.
4. Heat sink is optional and P/N7G-00297G-00307G-00317G-0032.
5. The QEB125 meets level A and level B conducted emissions only with external components connected before the input pin to the converter.
6. Typical value at nominal input voltage and full load
7. BASEPLATE GROUNGINGBase-plate should be grounded at one of the four screw bolts prior to operation.
8. The converter is provided by basic insulation.
(7)
EXTERNAL OUTPUT TRIMMING
Output can be externally trimmed by
using the method shown below.
TRIM UP
7
TRIM DOWN
6
RU
RD
6
5
PIN CONNECTION
PIN
Define
1
- INPUT
2
ON/OFF
3
+ INPUT
4
- OUTPUT
5
- SENSE
6
TRIM
7
+ SENSE
8
+ OUTPUT
PRODUCT OPTIONS TABLE
Option
Suffix
Negative remote ON/OFF logic, 0.20” pin length (standard) -
Negative remote ON/OFF logic, 0.145” pin length
-L
Negative remote ON/OFF logic, 0.11” pin length
-K
Positive remote ON/OFF logic, 0.20” pin length
-P
Positive remote ON/OFF logic, 0.145” pin length
-S
Positive remote ON/OFF logic, 0.11” pin length
-M
ExampleQEB125-48S3P3-P