MSE570 Datasheet, PDF (2/4 Pages) List of Unclassifed Manufacturers – Amp Bi-polar stepper motor drive

Specification
MSE570
Type without front panel
Type with front panel
Supply Voltage
Current consumption
Output Stage
Step logic
Logic Supply Voltage
Output Stage
Output current per phase
Step logic
Control signals
Logic 0: ( Low )
Logic 1: ( high )
Monitor Outputs
Low Level
High Level
Auxiliary outputs
Up-grade options
On board Oscillator
Thermal Protection
Condition monitoring
Dimensions
Vdc
Amps
Vdc
Amps
Volts
Volts
Volts
Volts
Vdc
Vdc
Mm
MSE570
PM 570
15-36 + 10% max.
1-3 A
2 Phase Bi-polar
Full step / half step
15-24 + 10% max
Notes
Max ripple: 3 V peak/Peak
Depending on motor selected
Chopped constant current
Open circuit for full step
Use motor supply if < 24 Vdc
2 Phase Bi-polar
0.5 to 3.5
Full step / half step
CMOS Schmidt trigger
0 to 2
9V to 30V max.
Open collector NPN transistor
1 max.
Open Circuit
Regulated +12 @ 50mA max.
Regulated + 5 @ 50mA max.
Optional
Optional
Optional
100 high x 160 long x 60
Chopped constant current
Set by on-board DIP switch
Open circuit for full step
@ 12V with 10KΩ pull-up resistors
& diode isolation
or contact closure to 0V
or open circuit
Referenced to 0V
@ 30mA max.
+ 24V max.
For use with on-board oscillator
User fit options: refer to manual
Std. Eurocard : Use12E wide panel
Typical Connections
CA
2o o
4o o
6o o
8o o
10 o o
12 o o
14 o o
16 o o
18 o o
20 o o
22 o o
24 o o
26 o o
28 o o
30 o o
32 o o
Motor Supply ( 15 to 36 Vdc)
Phase A
Phase A’
Phase B
Phase B’
Sync input/output
Home output
Direction ( cw / ccw ) input
Step ( Clock ) input
Full/ half step input
Reset input
Output disable input
Current reduction input
Overload output signal
Over temperature output
Oscillator speed control input *
Oscillator clock output *
Oscillator base speed input *
Oscillator run/stop input *
+12 Vdc output ( 50 mA)
+ 5 Vdc output ( 50 mA )
Logic Supply ( 15-24 Vdc )
Connect to motor rail as
shown when < 24 Vdc
0V Common
Connector: 32 way a & c DIN41612 type D
External Oscillator connections *
+12V
Pin 26a
VR2 high speed set
Max
Min
0V
Pin 30a
Base speed
VCO input
Pin 22a
High speed
base speed
Pin 24a
VR1
Stop
Base
Speed
set
Pin 24 c
Run
Oscillator Frequency
High / base switch
10 kHz Max typical setting
high speed
high
run
base speed
stop switch
Time
Note* Oscillator connections when circuit is fitted to MSE 570 Printed circuit board
Mclennan Servo Supplies Ltd. Tel: [phone] www.mclennan.co.uk