2430-002 Datasheet, PDF (2/3 Pages) List of Unclassifed Manufacturers – TRIAXIAL ANALOG ACCELEROMETER MODULE

Model 2430 Triaxial Analog Accelerometer Module
SIGNAL DESCRIPTIONS
+VS (Power): Reddish brown wire. Apply +11 to +16 Volts
DC with respect to OUTPUT REF.
-VS (Power): Black wire. Apply -11 to -16 Volts DC with
respect to OUTPUT REF.
OUTPUT REF (Input): White wire. The X, Y & Z outputs
are referenced to this potential. This input is usually
tied to a potential halfway between the +VS and -VS
voltages. This input may also be used to offset the
output but the voltage difference between this input
and either supply voltage (+VS or -VS) must be greater
than or equal to 7V.
X, Y & Z (Outputs): Green, Light Brown & Light Blue wires
respectively. These output voltages are proportional
to acceleration; they increase with positive
acceleration and decrease with negative acceleration.
At zero acceleration the output is nominally equal to
zero volts with respect to OUTPUT REF.
PERFORMANCE - By Model: V_S=±12 to ±16VDC, T_C=25EC.
MODEL NUMBER
2430-002 2430-005 2430-010 2430-025 2430-050 2430-100 2430-200
Input Range
±2
±5
±10 ±25 ±50 ±100 ±200
Frequency Response (Nominal, 3 dB) 0 - 300 0 - 400 0 - 600 0 - 1000 0 - 1500 0 - 2000 0 - 2500
Sensitivity
2500 1000 500 200 100
50
25
Output Noise (RMS, typical)
15
38
76
190 380 760 1520
Max. Mechanical Shock (0.1 ms)
2000
UNITS
g
Hz
mV/g
µg/(root Hz)
g
PERFORMANCE - All Models: Unless otherwise specified V_S=±12 to ±16VDC, T_C=25EC.
PARAMETER
MIN
TYP
MAX
UNITS
Cross Axis Sensitivity
2
3
%
Bias Calibration Error
-002
-005 thru -200
2
4
3
% of span
Bias Temperature Shift
(T_C= -40 to +85EC)
Scale Factor Calibration Error ¹
-002 & -005
-010 thru -200
100
50
300
200
(ppm of span)/EC
2
3
%
Scale Factor Temperature Shift (T_C= -40 to +85EC)
Non-Linearity
(-90 to +90% of Full Scale) ¹
-002 thru -100
-200
+300
0.5
1.0
0.7
1.5
ppm/EC
% of span
Power Supply Rejection Ratio
50
>65
dB
Output Impedance
Operating Voltage (V_S)
Operating Current (X, Y & Z outputs open) ³
1
±11 ²
±16
30
40
Ohm
V
mA
Mass (not including cable)
30
grams
Cable Mass
15
Notes: 1. 100g versions and above are tested from -65g to +65g.
2. Operation with V_S below ±12V may result in some performance degradation.
3. Power source must be capable of providing 3 times the operating current at turn-on.
grams/meter
Silicon Designs, Inc. ! 1445-NW Mall Street, Issaquah, WA 98027-5344 ! Phone: [phone] ! Fax: [phone]
web site: www.silicondesigns.com
[page 2]
Jan 08