TFP401_07 Datasheet, PDF (16/20 Pages) List of Unclassifed Manufacturers – PanelBus DIGITAL RECEIVER

TFP401, TFP401A
TI PanelBus DIGITAL RECEIVER
SLDS120B - MARCH 2000 − REVISED JUNE 2003
TI PowerPAD 100-TQFP package
The TFP401/401A is packaged in TI’s thermally enhanced PowerPAD 100TQFP packaging. The PowerPAD
package is a 14 mm × 14 mm × 1 mm TQFP outline with 0.5 mm lead-pitch. The PowerPAD package has a
specially designed die mount pad that offers improved thermal capability over typical TQFP packages of the
same outline. The TI 100-TQFP PowerPAD package offers a back-side solder plane that connects directly
to the die mount pad for enhanced thermal conduction. Soldering the back side of the TFP401/401A to the
application board is not required thermally as the device power dissipation is well within the package capability
when not soldered.
Soldering the back side of the device to the PCB ground plane is recommended for electrical considerations.
Since the die pad is electrically connected to the chip substrate and hence chip ground, connection of the
PowerPAD back side to a PCB ground plane will help to improve EMI, ground bounce, and power supply noise
performance.
Table 1 outlines the thermal properties of the TI 100-TQFP PowerPAD package. The 100-TQFP non-
PowerPAD package is included only for reference.
Table 1. TI 100-TQFP (14 × 14 × 1 mm)/0.5 mm Lead Pitch
PARAMETER
WITHOUT
PowerPAD
Theta-JA†,‡
45°C/W
Theta-JC†,‡
3.11°C/W
Maximum power dissipation†,‡,§
1.6 W
† _{Specified with 2 oz. Cu PCB plating.}
‡ _{Airflow is at 0 LFM (no airflow)}
§ _{Measured at ambient temperature, TA = 70°C.}
PowerPAD
NOT CONNECTED TO PCB
THERMAL PLANE
27.3°C/W
0.12°C/W
2.7 W
PowerPAD
CONNECTED TO PCB
THERMAL PLANE†
17.3°C/W
0.12°C/W
4.3 W
16
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265