CHS-06TA1 Datasheet, PDF (12/15 Pages) List of Unclassifed Manufacturers – SURFACE MOUNT TYPE SLIDE SWITCHES

COPAL ELECTRONICS
CHS
SLIDE SWITCHES (SMD)
s SOLDERING CONDITIONS
q Soldering iron
3 s maximum at 300 °C
q Vapor-phase soldering
215 °C, less than 35 s
q Infrared reflow soldering
The temperature profile shown at right is recommended
for reflow soldering. However, process carefully in case
of infrared heater, because the absoription rate of the
object may vary according to its color, material, etc. and
thus heating rate can be different. Please note that the
surface temperature of the product should not exceed
240 ˚C. When the product temperature exceeds 250 ˚C,
deformation may occur due to heat.
s PACKAGING SPECIFICATIONS
<Taping packaging specifications>
q Taping version is packaged in 500 pcs. per reel.
Orders will be accepted for units of 500 pcs., i.e.,
500, 1000, 1500 pcs., etc.
q Taping version is boxed with two reels (1000 pcs.).
q Embossed tape dimensions
3 ~ 4 min
Tp
Tm
tm
Time
Tp 240 °C(Peak temperature)
Tm 180 °C(Melting point temperature)
tm 10 s(Melting time)
Maximum number of consecutive missing pieces=2
Leader length and reel dimension are shown in the
diagrams below:
q Reel dimensions
(Unit: mm)
Empty
Filled
Empty
End
Head
40 mm min.
Direction of feed
20 pitches min.
Leader
400 mm min.
21±0.8
2±0.5
13±0.2
250±2
16.4
+2
0
(1, 2,4,6 bits)
24.4
+2
0
(8,10 bits)
22.4 max. (2,4,6 bits)
30.4 max. (8,10 bits)
q Reel & embossed tapematerials
Embossed tape: Plastic
Reel: Paper
q Embossed tape pull strength
10 N {1.02 kgf} minimum
q Peeling strength of seal tape
0.1~0.7 N {10.2~71.4 gf}
{ } : Reference only
q Test method for peeling strength of seal tape
Seal cover tape
165°~180°
Peel direction
(300 mm/min)
Direction of feed
Carrier tape
s Specifications are subject to change without notice. Specifications in this catalog are for reference. The formal specification sheets will be submitted upon request.