English
Language : 

B104SN01 Datasheet, PDF (11/17 Pages) List of Unclassifed Manufacturers – Module Specification for 10,4 TFT-LCD MODULES
PA G E
: 9/15
e.Backlight driving conditions
Parameter
Symbol
Min.
Typ.
Max.
Unit
Remark
Lamp voltage
VL
Lamp current
IL
Power consumption
PL
Lamp starting voltage
VS
-
488
-
Vrms
Note 1
-
4.3
-
mArms Note 1
-
2.1
-
W
Note 2
TBD
TBD
Vrms
T=0

T=25

Frequency
FL
-
60
-
KHZ
Note 3
Lamp life time
LL
10000
-
-
Hr
Note 1, 4
Note 1: T= 25

, IL = 4.3
Note 2: Inverter should be designed with the characteristic of lamp. When you are designing
the inverter, the output voltage of the inverter should comply with the following
conditions.
(1).The area under the positive and negative cycles of the waveform of the lamp
current and lamp voltage should be area symmetric(the symmetric ratio should be
larger than 90%).
(2).There should not be any spikes in the waveform.
(3).The waveform should be sine wave as possible.
(4).Lamp current should not exceed the maximum value within the operating
temperature (It is prohibited to over the maximum lamp current even if operated in
the non-guaranteed temperature). When lamp current over the maximum value for
a long time, it may cause fire. Therefore, it is recommend that the inverter should
have the current limiter circuit.
Note 3: Lamp frequency may produce interference with horizontal synchronous frequency and
this may cause line flow on the display. Therefore lamp frequency shall be detached
from the horizontal synchronous frequency and its harmonics as far as possible in
order to avoid interference. In case using the inverter by PWM control, PWM
frequency may interference with frame frequency. We suggest that PWM frequency
is same as frame frequency.
Note 4: Brightness to be decrease to the 50% of the initial value.
Note 5: CN2 connector(backlight): JST BHSR-02VS-1
Mating connector: JST SM02B-BHSS-1-TB
Pin no.
1
2
Symbol
H
L
Function
CCFL power supply(H.V.)
CCFL power supply(GND)
Remark
Cable color: Pink
Cable color: White
DATA MODUL AG Landsberger Str. 322 80687 München Tel.: 089/ 56017-0 Fax 089/ 56017-119
www.data-modul.de