ST7565S Datasheet, PDF (1/73 Pages) List of Unclassifed Manufacturers – 65 x 132 Dot Matrix LCD Controller/Driver

Sitronix
ST
ST7565S
65 x 132 Dot Matrix LCD Controller/Driver
FEATURES
z Direct display of RAM data through the display data
RAM.
z RAM capacity : 65 x 132 = 8580 bits
z Display duty selectable by select pin
1/65 duty : 65 common x 132 segment
1/49 duty : 49 common x 132 segment
1/33 duty : 33 common x 132 segment
1/55 duty : 55 common x 132 segment
1/53 duty : 53 common x 132 segment
z High-speed 8-bit MPU interface (The chip can be
connected directly to the both the 80x86 series MPUs
and the 68000 series MPUs)
/Serial interfaces are supported.
z Abundant command functions
Display data Read/Write, display ON/OFF, Normal/
Reverse display mode, page address set, display start
line set, column address set, status read, display all
points ON/OFF, LCD bias set, electronic volume,
read/modify/write, segment driver direction selects,
power saver, static indicator, common output status
select, V5 voltage regulation internal resistor ratio set.
z Static drive circuit equipped internally for indicators.
(1 system, with variable flashing speed.)
z Low-power liquid crystal display power supply circuit
equipped internally.
Booster circuit (with Boost ratios of 2X/3X/4X/5X/6X
, where the step-up voltage reference power
supply can be input externally).
High-accuracy voltage adjustment circuit (Thermal
gradient –0.05%/°C ) V5 voltage regulator resistors
equipped internally, V1 to V4 voltage divider resistors
equipped internally, electronic volume function
equipped internally, voltage follower.
z CR oscillator circuit equipped internally (external
clock can also be input)
z Extremely low power consumption Operating power
when the built-in power supply is used (an example)
60uA (VDD – VSS = VDD – VSS2 =3.0 V, Quad voltage,
V5 – VDD = – 11.0 V).
Conditions: When displays pattern OFF and the
normal mode is selected.
z Power supply operate on the low 1.8 voltage
Logic power supply
VDD – VSS = 1.8V to 3.3 V (+10% Range)
Boost reference voltage: VDD – VSS2 = 1.8V to 3.3V
Booster maximum voltage limited
VOUT= -13V (+10% Range)
Liquid crystal drive power supply:
VDD – V5 = 4.0V to 13.0 V
z Wide range of operating temperatures: –40 to 85°C
z CMOS process
z Shipping forms include bare chip and TCP.
z These chips not designed for resistance to light or
resistance to radiation.
GENERAL DESCRIPTION
The ST7565S is a single-chip dot matrix LCD driver that can
be connected directly to a microprocessor bus. 8-bit parallel
or serial display data sent from the microprocessor is stored
in the internal display data RAM and the chip generates a
LCD drive signal independent of the microprocessor.
Because the chips in the ST7565S contain 65x132 bits of
display data RAM and there is a 1-to-1 correspondence
between the LCD panel pixels and the internal RAM bits,
these chips enable displays with a high degree of freedom.
The ST7565S chips contain 65 common output circuits and
132 segment output circuits, so that a single chip can drive a
65x132 dot display (capable of displaying 8 columnsx4 rows
of a 16x16 dot kanji font).
Moreover, the capacity of the display can be extended
through the use of master/slave structures between chips.
The chips are able to minimize power consumption
because no external operating clock is necessary for the
display data RAM read/write operation. Furthermore,
because each chip is equipped internally with a low-power
LCD driver power supply, resistors for LCD driver power
voltage adjustment and a display clock CR oscillator circuit,
the ST7565S can be used to create the lowest power display
system with the fewest components for high-performance
portable devices.
Ver 0.3c
PART NO.
ST7565S
VRS temperature gradient
-0.05%/°C
1/73
VRS range
-2.1V ±0.03V
2002/07/22