MXD6125Q Datasheet, PDF (1/6 Pages) List of Unclassifed Manufacturers – Ultra High Performance ±1g Dual Axis Accelerometer with Digital Outputs

Ultra High Performance
±1g Dual Axis Accelerometer with
Digital Outputs
MXD6125Q
FEATURES
Ultra Low Noise 0.13 mg/ Hz typical
Ultra Low Offset Drift 0.1 mg/°C typical
Resolution better than 1 mg
Monolithic CMOS IC
On chip mixed signal processing
50,000 g shock survival rating
Low profile LCC package
2.7V to 3.6V single supply
No adjustment needed outside
APPLICATIONS
Automotive – Vehicle Security/Active Suspension/ABS
Headlight Angle Control/Tilt Sensing
Security – Gas Line/Elevator/Fatigue Sensing
Office Equipment – Computer Peripherals/PDA’s/Mouse
Smart Pens/Cell Phones
Gaming – Joystick/RF Interface/Menu Selection/Tilt Sensing
MXD6125Q FUNCTIONAL BLOCK DIAGRAM
GENERAL DESCRIPTION
The MXD6125Q is a low noise, low profile, dual axis
accelerometer fabricated on a standard CMOS process. It is
a complete sensing system with on-chip mixed mode signal
processing. The MXD6125Q measures acceleration with a
full-scale range of ±1 g and a sensitivity of 12.5%/g @3V at
25°C. It can measure both dynamic acceleration (e.g.,
vibration) and static acceleration (e.g., gravity). The
MXD6125Q design is based on heat convection and requires
no solid proof mass. This eliminates stiction and particle
issues normally found with capacitive based technology, and
significantly lowers field failure rate and in-line loss due to
handling during assembly.
.
The MXD6125Q provides two ratiometric analog outputs.
The maximum noise floor is 0.18 mg/ Hz allowing signals
below 0.5 mg to be resolved at 1 Hz bandwidth and the 3dB
rolloff of the device occurs at 8 Hz. The MXD6125Q is
available in a hermetically sealed low profile LCC surface
mount package measuring 5mm x 5mm x 1.55m.
Information furnished by MEMSIC is believed to be accurate and reliable. However,
no responsibility is assumed by MEMSIC for its use, nor for any infringements of
patents or other rights of third parties which may result from its use. No license is
granted by implication or otherwise under any patent or patent rights of MEMSIC.
©MEMSIC, Inc.
800 Turnpike St., Suite 202, North Andover, MA 01845
Tel: [phone]
Fax: [phone]
www.memsic.com
MEMSIC MXD6125Q
Page 1 of 6
2/24/2005