MSK4221 Datasheet, PDF (1/5 Pages) List of Unclassifed Manufacturers – 75 VOLT 8 AMP MOSFET H-BRIDGE PWM MOTOR DRIVER/AMPLIFIER

ISO 9001 CERTIFIED BY DSCC
M.S.KENNEDY CORP.
4221 ^{75 VOLT 8 AMP MOSFET}
H-BRIDGE PWM MOTOR
DRIVER/AMPLIFIER
4707 Dey Road Liverpool, N.Y. 13088
[phone]
FEATURES:
Low Cost Complete H-Bridge
8 Amp Capability, 75 Volt Maximum Rating
Self-contained Smart Lowside/Highside Drive Circuitry
Shoot-through Protection
Isolated Case Allows Direct Heatsinking
Four Quadrant Operation, Torque Control Capability
Logic Level Disable Input
Logic Level High Side Enable Input for Special Modulation or Function
Internal Divider Reference for Threshold Voltage
DESCRIPTION:
The MSK 4221 is a complete H-Bridge circuit to be used for DC brushed motor control or Class D switchmode
amplifiers. All of the drive/control circuitry for the lowside and highside switches are included internally. The user
provides a digitally compatible PWM signal (a reference divider is provided for TTL compatability or the user provides
their own to the VREF IN) for simultaneous amplitude and direction control in four quadrant mode. The internal drive
circuitry will provide proper deadtime/shoot-through protection for each half-bridge. All N-channel FETs mean the
best efficiency for the size, both in terms of on-resistance and switching capability. For an idle/sleep mode or for fault
protection, a TTL compatible disable pin is provided so as to shut down all four transistors. The MSK4221 is
constructed on a space efficient ceramic coated insulated metal substrate that can be directly connected to a heat
sink.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
PIN-OUT INFORMATION
1 HEN
2 Disable
3 Input
4 Vref in
5 Ground
6 Ground
7 Vref out
8 Vcc
9 Output A
18 Output B
17 Output B
16 Rsense B
15 Rsense B
14 V+
13 V+
12 Rsense A
11 Rsense A
10 Output A
1
Rev. C 6/00