MAG-725M4 Datasheet, PDF (1/21 Pages) Agilent(Hewlett-Packard) – Agilent MGA-725M4 Low Noise Amplifier with Bypass Switch In Miniature Leadless Package

Agilent MGA-725M4 Low Noise
Amplifier with Bypass Switch In
Miniature Leadless Package
Data Sheet
Description
Agilent Technologies’s
MGA-725M4 is an economical,
easy-to-use GaAs MMIC Low
Noise Amplifier (LNA), which is
designed for an adaptive CDMA
receiver LNA and adaptive CDMA
transmit driver amplifier.
The MGA-725M4 features a typical
noise figure of 1.4 dB and 14.4 dB
associated gain from a single
stage, feedback FET amplifier.
The output is internally matched
to 50Ω. The input is optimally
internally matched for lowest
noise figure into 50Ω. The input
may be additionally externally
matched for low VSWR through
the addition of a single series
inductor. When set into the bypass
mode, both input and output are
internally matched to 50Ω.
Simplified Schematic
Input
&
V_ref
Control
GainFET
Output
& V_d
The MGA-725M4 offers an
integrated solution of LNA with
adjustable IIP3. The IIP3 can be
fixed to a desired current level for
the receiver’s linearity require-
ments. The LNA has a bypass
switch function, which sets the
current to zero and provides low
insertion loss. The bypass mode
also boosts dynamic range when
high level signal is being received.
For the CDMA driver amplifier
applications, the MGA-725M4
provides suitable gain and linear-
ity to meet the ACPR requirement
when the handset transmits the
highest power. When transmitting
lower power, the MGA-725M4 can
be bypassed, saving the drawing
current.
The MGA-725M4 is a GaAs MMIC,
processed on Agilent’s cost
effective PHEMT (Pseudomorphic
High Electron Mobility Transistor).
It is housed in the MiniPak 1412
package. It is part of the Agilent
Technologies CDMAdvantage RF
chipset.
Features
• Operating frequency:
0.1 GHz ~ 6.0 GHz
• Noise figure:
1.2 dB at 800 MHz
1.4 dB at 1900 MHz
• Gain:
17.5 dB at 800 MHz
15.7 dB at 1900 MHz
• Bypass switch on chip
Loss = typ 1.6 dB (I_d < 5 µA)
IIP3 = +10 dBm
• Adjustable Input IP3:
+2 to +14.7 dBm
• Miniature package:
1.4 mm x 1.2 mm
2.7 V to 5.0 V operation
Applications
• CDMA (IS-95, J-STD-008) Receiver
LNA
• Transmit Driver Amp
• TDMA (IS-136) handsets
MiniPak 1.4 mm x 1.2 mm Package
Ax
Pin Connections and
Package Marking
GROUND
INPUT
Ax
OUTPUT
GROUND
GND
GND