IP1000ALF Datasheet, PDF (1/75 Pages) List of Unclassifed Manufacturers – Gigabit Ethernet NIC Single Chip

IP1000A LF
Preliminary Data Sheet
Gigabit Ethernet NIC Single Chip
Features
PCI & DMA Features
– PCI Specification Revision 2.3 compliant
– 32-bit, 33/66MHz bus master capability
– Efficient DMA operation maximizes PCI
band-width utilization
– 1 Terabyte (40 bit) address space
– Scatter, gather transmit/receive DMA
– Transmit "interrupt-less" mode of
operation
– Receive frame priority interrupts
– Receive interrupt coalescing
FIFO Features
– No external memory required
– Receive FIFO flow control thresholds
– Configurable TX/RX FIFO
MAC Features
– IEEE 802.3z, 802.3x compliant
– IEEE 802.1p, 802.1Q compliant
– 1000Mbps, 100Mbps, 10Mbps triple
speed, half/full duplex operation
– Transmit and receive back to back frames
at full wire speed
– Half duplex carrier extension and packet
bursting
– Asymmetric/symmetric flow control
– VLAN tag insertion/removal
– VLAN tagged frame filtering
– IPV4/6, TCP, UDP checksum calculation/
verification
– 802.3 MIB statistic register sets
– 64-bit hash table for multicast frame
filtering
– Jumbo frame support for transmit/receive
– Big-endian
Phsical Layer Features
– Fully integrated IEEE 802.3ab compliant
1000BASE-T, 100BASE-TX and
10BASE-T port
– DSP receiver includes feed-forward
equalizer, decision feedback equalizer,
echo canceller, crosstalk canceller, and
baseline wander correction
– 802.3ab compliant Auto-Negotiation for
automatic speed, duplex, and
master/slave configuration
– Automatic MDI/MDI-X crossover function
and polarity correction
– Automatic pair skew adjustment
– PHY management registers
– Smart Cable Analyzer (SCA™)
– Smart speed downshift
– APS(Auto Power Saving)
a. Power Saving with Link status detecting
b. Keep only MAC alive through
software setting
Power Management, EEPROM and Package
– WakeOnLAN support
– ACPI Revision 1.0 compliant
– 1.8/3.3V CMOS with 5V tolerant I/O
– EEPROM 93C46 support
– Optional boot from serial ROM support
– 128-pin LQFP with e-PAD package
Support Lead Free package (Please refer to
the Order Information)
General Description
The IP1000A LF is a truly 10/100/1000Mbps
Gigabit Ethernet NIC single chip which it
incorporates a 32-bit PCI interface with bus
master support. It is manufactured using standard
digital CMOS process and contains all the active
circuitry required to implement the physical layer
functions to transmit and receive data on standard
CAT5 unshielded twisted pair cable.
The IP1000A LF is designed for use in a variety of
applications including workstation NICs, and other
systems utilizing a PCI bus.
The IP1000A LF includes a 32-bit PCI bus
interface, IEEE 802.3 compliant MAC, transmit
and receive FIFO buffers, IEEE 802.3 compliant
10BASE-T, and 100BASE-TX PHY, IEEE 802.3z
compliant 1000 BASE-T PHY, serial EEPROM
interface, expansion ROM interface and LED
drivers.
The IP1000A LF supports features for use in
“Green PCs” or systems where control over
system power consumption is desired. The
IP1000A LF supports several power down states,
and the ability to issue a system “wake event” via
reception of unique, user defined Ethernet frames.
In addition, the IP1000A LF can assert a wake
event in response to changes in the Ethernet link
status.
1/75
Copyright © 2005, IC Plus Corp.
July 5, 2005
IP1000A LF-DS-R08