IN2418 Datasheet, PDF (1/3 Pages) List of Unclassifed Manufacturers – Telephone Tone Ringer with Bridge Diode

TECHNICAL DATA
Telephone Tone Ringer with
Bridge Diode
IN2418
The IN2418 is a monolithic integrated circuit telephone tone ringer
with bridge diode, when coupled with an appropriate transducer, it
replaces the electro-mechanical bell. The device is designed for use
with either a piezo transducer or an inexpensive transformer coupled
speaker to produce a pleasing tone composed of a high frequency (f_R)
alternating with a low frequency (f_L) resulting in a warble frequency.
The supply voltage is obtained from the AC ring signal and the circuit
is designed so that noise on the line or variation of the ringing signal
can not affect correct operation of the device.
• On chip high voltage full wave diode bridge rectifier
• Low current consumption, in order to allow the parallel operation
of the 4 devices
• Low external component count
• Tone and switching frequencies adjustable by external
components
• High noise immunity due to built-in voltage-current hysteresis
• Activation voltage adjustable
• Internal zener diodes to protect against over voltages
• Ringer impedance adjustable with external components
ORDERING INFORMATION
IN2418N Plastic
T_A = -20° to 70° C
for package
PIN ASSIGNMENT
BLOCK DIAGRAM
1