CP800 Datasheet, PDF (1/3 Pages) Pan Jit International Inc. – SINGLE-PHASE SILICON BRIDGE(VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A)

CP800 Series
Single Phase Bridge Rectifiers
Features:
• High surge current capability.
• PCB mounted/screw fixing.
• Surge overload rating: 200 Amperes peak.
• Low forward voltage drop and reverse leakage.
• Small size, simple installation.
• Reliable low cost construction utilizing moulded plastic technique.
Mechanical Data:
Mounting position
Terminals
Mounting
: Any.
: Leads solderable per MIL-
STD-202, Method 208.
: Through hole for a number 6
screw.
Dimensions : Inches (Millimetres)
Maximum Ratings and Electrical Characteristics
At 25°C ambient temperature unless otherwise noted; resistive or inductive load at 60Hz.
Parameter
CP802
CP806 CP808
Unit
Maximum recurrent peak reverse voltage
Maximum bridge input voltage RMS
200
600
800
V
140
420
560
Maximum average rectified output at
see Figure 2
T_C = 50°C
T_A = 40°C
8.0
3.0
A
Peak one cycle surge overload current
200
A
Maximum forward voltage drop per element at 4.0A dc and 25°C
see Figure 3
1.1
V
Maximum reverse leakage at rated DC blocking voltage per element at 25°C
10.0
µA
See Figure 4
at 100°C
1.0
mA
I²t Rating for fusing ( t<8.3ms)
166
A² seconds
Typical junction capacitance per leg (Note 4) CJ
200
pF
Typical thermal resistance per leg (Note 3) RθJA
Typical thermal resistance per leg (Note 2) RθJL
21
6
°C/W
Operating temperature range
Storage temperature range
-55 to +125
°C
-55 to +150
Notes:
1. Bolt down on to a heat-sink with silicon thermal compound between bridge and mounting surface for maximum heat transfer with a
number 6 screw.
2. Units Mounted on a 8.6” x 8.6” x 24” thick (22 x 22 x 0.6cm) Aluminium plate heatsink.
3. Units Mounted on PCB at 0.375” (9.5mm) lead length with 0.5” x 0.5” (12 x 12mm) copper pads.
4. Measured at 1.0MHz and applied reverse voltage.
Page 1
31/05/05 V1.0