|
BCM5388 Datasheet, PDF (1/2 Pages) Broadcom Corporation. – 8 GE PORT SWITCH WITH INTEGRATED GE COPPER PHY | |||
|
BCM5388
®
8GE PORT SWITCH WITH INTEGRATED GE COPPER PHY
FEATURES
SUMMARY OF BENEFITS
⢠Highest silicon integration level achieved for an 8-port, 10/100/1000
Ethernet switch device
⢠Seventh-generation switch on a chip
⢠Integrates:
Four 10/100/1000 transceivers (802.3ab compliant)
Eight MACs (802.x compliant) with support for 9kByte Jumbo Frames
4 RGMII Interfaces and 128-KByte packet buffer memory
Nonblocking 8 Gigabit Ethernet fully integrated switch fabric
SPI Interface for easy setup and smart unmanaged operation
⢠Classifies packets using 4 802.1p QoS or DiffServ/TOS priority queues
⢠VLAN 4K 802.1Q or port-based supported
⢠Supports up to 8k unicast MAC addresses
⢠Supports MAC-based port aggregation (trunking)
⢠Flow control: Full-duplex (802.3x) and half-duplex options supported
⢠Supports automatic address learning and aging
⢠Internal oscillator circuit
⢠Low power 0.13 µm 1.2 V CMOS core: <5W Pd.
⢠Fanless operation supported
⢠Integrated voltage regulator for simplified power supply design
⢠324-pin FBGA package (small form factor 19 mm x 19 mm)
⢠Enables a new generation of lower cost switches with Gigabit Ethernet
connectivity and much smaller form factors.
⢠Uses field-proven industry-standard 10/100/1000BASE-T
transceivers-lowers overall system interoperability and reliability
risks.
⢠Provides the most cost effective Gigabit Ethernet connectivity to the
desktop for all remote, branch, and home office needs.
⢠802.1Q tag VLAN, trunking, and 802.1p priority enables the switch to
be designed into a wide variety of applications from unmanaged to
smart switch.
⢠Jumbo frame support allows the device to be connected to corporate
server farms and networks while maintaining maximum TCP/IP
performance
⢠CPUs are not required to initialize and run in cost-sensitive
unmanaged applications, providing true Plug and Play connectivity.
⢠Internal oscillator circuit simplifies design and reduces overall system
cost.
⢠On-chip HP auto-MDI/MDIX on all tranceivers automatically detects
and corrects for crossover cables and allows direct switch-to-switch
connection.
⢠Lowest possible system cost through minimized number of
components
⢠Higher system reliability and noise reduction due to elimination of
component with lowest MTBF (the fan)
8 Gigabit Ethernet Ports for SOHO and Subnetwork Applications
Uplink
Copper or Fiber
Printer
Cable/DSL/Wireless
Router
IP Phones
Server
|
▷ |