500-30-100-35-E3 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – RF POWER AMPLIFIER MODULE

RF POWER
AMPLIFIER MODULE
Model A072
P/N 500-30-100-35-E3
Small Size
High Efficiency
Low Even Order Harmonics
Rugged
30 - 500 MHz
100 Watts
Gain: 35 dB Voltage: 28 VDC
PERFORMANCE
PARAMETER
RF Output Power
Frequency Range
Gain
Main DC Supply
Bias Supply
Efficiency
Harmonics / Spurious
In / Out Impedance
RF In / Out Connectors
DC Connectors
Size / Weight
Operating Temperature
Humidity
Vibration
Altitude
SPECIFICATIONS
100 Watts cw minimum
30 - 500 MHz
35 dB minimum
28 VDC, 12 Amp maximum
15 VDC, 10 mA maximum
35 - 45 % typical
See Plot / Spurious <-60 dBc
SMA Female
Solderable filtered feed throughs with ground
lugs
6.0" x 2.5" x 1.25" / < 1 lb.
-50 B C to +60B C
95 - 100 %
110 G Shock
50,000 feet
COMMENTS
Class AB linear
40 dB typical
8 to 11 Amp typical at 100 W output
(see Note 1)
Provides enable/disable control (see Note 2)
Designed for small size, high efficiency;
compatible with 50 ohms
Consult technical support for higher
temperature operation.
OPEN ARCHITECTURE FEATURES
1. Separate bias inputs and power supply feed throughs permit either Class A or Class AB biasing. Bias off disables amplifier
2. Separate power supply terminals for each push/pull section permit individual fuse protection.
3. A low loss output matching network provides high efficiency and optimum stability.
OPTIONS AVAILABLE
• Higher powers through multiple module combining
• Inside wiring with only one DC connection
• Detailed Application Notes
• Transmit/Receive Subsystems
• TTL compatible enable/disable control
• Narrower band optimization. ( no additional cost)
• Complete rackmount 120/220 VAC systems
• Test fixture with heat sink, fuse protection, and thermal
LCF Enterprises
6180 Commerce Loop
Post Falls, ID 83854
E-Mail: [e-mail]
Tel: [phone]
FAX: [phone]
Web: www.lcfamps.com