EQCO-SDI30-7501 Datasheet, PDF (1/2 Pages) EqcoLogic – EqcoLogic HD-SDI Repeaters for long-haul digital HD-CCTV

Open your Eyes™
EqcoLogic HD-SDI Repeaters for long-haul digital HD-CCTV
Extend HD-CCTV links up to 1.0km
with power over cable and camera
control link over single coax cable
EqcoLogic’s EQCO-SDI30-7501 is an extender solution
for HD-SDI links, operating with 75Ω coax cable.
Each unit receives a HD-CCTV signal that may be
attenuated by up to 220m of coax cable.
Implementation
Each repeater supports a date-rate of 2.97 Gbit/s (3G-
SDI). A link of up to 220m can be achieved with a data
-rate of 1.485 Gbit/s (depending on cable quality*).
Longer lengths can be supported with lower speed
cameras: for example, 720m for SDI cameras.
Up to 5 repeater units can be daisy-chained together,
all powered over the coax cable by power injected to
the first repeater.
The repeater contains three critical components to
correct and then retransmit the signal:
 Adaptive Equalizer to return the signal to its original
amplitude and modulation
 Reclocker to resynchronize the signal—bringing it
back to its original condition
 Cable Driver to retransmit the signal with its original
characteristics restored
Furthermore, the repeater design allows for two
unique benefits:
 Power can be transmitted from the recorder (DVR)
side to the camera over the coax cable.
 Up to 6 repeaters may be powered from the coax
cable; if only one or two repeaters are used, the
power may also be adequate to power the SDI
camera.
 A control signal (RS485) can be transmitted from the
recorder (DVR) side to the camera over the coax
cable
Repeater enables simultaneous signal transmission,
camera control and power over a single cable.
DVR side Repeater including Link Power and Control Channel
In-line HDSDI Repeater
Camera side HDSDI Repeater with Power and Control
Camera control signals and the system power can be
injected at the first repeater (nearest the recorder).
Control signals and camera power (if appropriate) can
similarly be taken from the repeater nearest to the
camera and fed into the camera itself.
The camera control is via RS485, the most commonly
used protocol and a control signal bandwidth of up to
38.4 kbps is supported.
www.eqcologic.com
*Subject to maximum cable attenuation, see over for details