SG-615 Datasheet, PDF (1/2 Pages) Epson Company – SOJ HIGH-FREQUENCY CRYSTAL OSCILLATOR

Crystal oscillator
SOJ HIGH-FREQUENCY CRYSTAL OSCILLATOR
SG-615 series
Product number (Please refer to P1)
Q3361 5xxxx xxx 00
• High-density mounting-type SMD.
• A general-purpose SMD with heat-resisting cylindrical AT-cut crystal unit
and allowing almost the same soldering temperature as SMD IC.
• Cylindrical AT crystal unit builtin, thus assuring high reliability.
• Low current consumption by output enable function(OE) or standby
function(ST).
Actual size
Specifications (characteristics)
Item
Symbol
SG-615P
Specifications
SG-615PTJ
SG-615PH
Remarks
Output frequency range
f0 _{1.0250 MHz to 26.0000 MHz}
26.0001 MHz to 66.6667 MHz
Refer to page 31. "Frequency range"
Power source
voltage
Temperature
range
Max. supply voltage
Operating voltage
Storage temperature
Operating temperature
Frequency stability
Current consumption
Output disable current
VDD-GND
VDD
TSTG
TOPR
∆f/f0
Iop
IOE
Duty
tw/t
Output voltage
VOH
VOL
Output load
CL
condition (fan out)
N
Output enable/disable input voltage
VIH
VIL
Output rise time
tTLH
Output fall time
tTHL
-0.3 V to +7.0 V
5.0 V±0.5 V
-55 °C to +125 °C
-20 °C to +70 °C (-40 °C to +85 °C)
B: ±50 x 10^-6
C: ±100 x 10^-6
23 mA Max.
35 mA Max.
12 mA Max.
28 mA Max.
20 mA Max.
40 % to 60 %
—
40 % to 60 %
45 % to 55 %
—
VDD -0.4 V Min.
2.4 V Min.
VDD -0.4 V Min.
0.4 V Max.
50 pF Max.
—
50 pF Max.
10 TTL Max.
5 TTL Max.
—
2.0 V Min.
3.5 V Min.
2.0 V Min.
0.8 V Max.
1.5 V Max.
0.8 V Max.
8 ns Max.
—
5 ns Max.
7 ns Max.
—
8 ns Max.
—
5 ns Max.
7 ns Max.
—
Stored as bare product after unpacking
Refer to page 31. "Frequency range"
B type is possible up to 55 MHz
No load condition
OE=GND
CMOS load: 1/2VDD
TTL load: 1.4 V
IOH = -400 µA (P,PTJ) /-4 mA (PH)
IOL = 16 mA (P) /8mA (PTJ) /4 mA (PH)
CL<_15 pF
IIH=1 µA Max.(OE=VDD)
IIL=-100 µA Min.(OE=GND) , PTJ : IIL=-500 µA Min.(OE=GND)
CMOS load: 20 %→80 % VDD
TTL load: 0.4 V→2.4 V
CMOS load: 80 %→20 % VDD
TTL load: 2.4 V→0.4 V
Oscillation start up time
tOSC
4 ms Max.
10 ms Max.
Time at 4.5 V to be 0 s
Aging
fa
Shock resistance
S.R.
±5 x 10^-6/year Max.
±20 x 10^-6 Max.
Ta= +25 °C, VDD = 5 V, first year
Three drops on a hard board from 750 mm
or excitation test with 29400 m/s² x 0.3 ms x
1/2sine wave in 3 directions
Note: • Unless otherwise stated, characteristics (specifications) shown in the above table are based on the rated operating temperature and voltage condition.
• External by-pass capacitor is recommended.
External dimensions
(Unit: mm)
Recommended soldering pattern ^{(Unit: mm)}
#4
#3
SE2G0-6.09103505P02MCA
NO. Pin terminal
1 _{OE or ST}
2 GND
3 OUT
1.3
4 VDD
#1
#2
14.0 Max.
0.51
5.08
7.62
Note.
OE Pin (P, PTJ, PH, PTW, PHW, PCW, PCN)
ST pin (STW, SHW, SCW)
5.08
OE pin - "H" or "open" : Specified frequency output.
ST pin - "H" or "open" : Specified frequency output.
OE pin - "L" : Output is high impedance.
ST pin - "L" : Output is low level (weak pull - down), oscillation stops.
43