B25630 Datasheet, PDF (4/16 Pages) EPCOS – Power Capacitors for Industrial Applications and Renewable Energy

Important Notes
The following applies to all products named in this
publication:
1. Some parts of this publication contain statements
about the suitability of our products for certain ar-
eas of application. These statements are based on our
knowledge of typical requirements that are often placed
on our products in the areas of application concerned.
We nevertheless expressly point out that such state-
ments cannot be regarded as binding statements
about the suitability of our products for a particular
customer application. As a rule, EPCOS is either unfa-
miliar with individual customer applications or less famil-
iar with them than the customers themselves. For these
reasons, it is always ultimately incumbent on the cus-
tomer to check and decide whether an EPCOS product
with the properties described in the product specification
is suitable for use in a particular customer application.
2. We also point out that in individual cases, a malfunc-
tion of electronic components or failure before the
end of their usual service life cannot be completely
ruled out in the current state of the art, even if they
are operated as specified. In customer applications re-
quiring a very high level of operational safety and espe-
cially in customer applications in which the malfunction
or failure of an electronic component could endanger
human life or health (e.g. in accident prevention or life-
saving systems), it must therefore be ensured by means
of suitable design of the customer application or other
action taken by the customer (e.g. installation of protec-
tive circuitry or redundancy) that no injury or damage is
sustained by third parties in the event of malfunction or
failure of an electronic component.
3. The warnings, cautions and product-specific notes
must be observed.
4. In order to satisfy certain technical requirements,
some of the products described in this publica-
tion may contain substances subject to restric-
tions in certain jurisdictions (e.g. because they are
classed as hazardous). Useful information on this will
be found in our Material Data Sheets on the Internet
(www.epcos.com/material). Should you have any more
detailed questions, please contact our sales offices.
5. We constantly strive to improve our products. Conse-
quently, the products described in this publication
may change from time to time. The same is true of
the corresponding product specifications. Please check
therefore to what extent product descriptions and speci-
fications contained in this publication are still applicable
before or when you place an order.
We also reserve the right to discontinue production
and delivery of products. Consequently, we cannot
guarantee that all products named in this publication will
always be available.
The aforementioned does not apply in the case of indi-
vidual agreements deviating from the foregoing for cus-
tomer-specific products.
6. Unless otherwise agreed in individual contracts, all or-
ders are subject to the current version of the “Gener-
al Terms of Delivery for Products and Services in the
Electrical Industry” published by the German Electri-
cal and Electronics Industry Association (ZVEI).
7. The trade names EPCOS, BAOKE, Alu-X, CeraDiode,
CSMP, CSSP, CTVS, DeltaCap, DigiSiMic, DSSP,
FormFit, MiniBlue, MiniCell, MKD, MKK, MLSC,
MotorCap, PCC, PhaseCap, PhaseCube, PhaseMod,
PhiCap, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD,
SiMic, SIMID, SineFormer, SIOV, SIP5D, SIP5K,
ThermoFuse, WindCap are trademarks registered
or pending in Europe and in other countries.
Further information will be found on the Internet at
www.epcos.com/trademarks.
4
Please read Important notes on page 4.
© EPCOS AG 2012