B72580V3140S272 Datasheet, PDF (3/67 Pages) EPCOS – Ceramic transient voltage suppressors

Multilayer varistors (MLVs)
Automotive series
Features
ESD protection up to 25 kV, ISO 10605 level IV, acc.
to IEC 61000-4-2 level 4 (8 kV contact, 15 kV air)
High energy absorption capability
Low leakage current
High temperature versions
Stable protection level
Bidirectional clamping
No temperature derating up to 125 °C
RoHS-compatible
Nickel barrier series suitable for lead-free soldering
Nickel barrier series qualified based on
AEC-Q200 rev. C
PSpice simulation models available
Applications
Transient overvoltage protection in automotive
applications: engine management, airbag, control
units, electrohydraulic brake, ABS/ESP, sunroof
Load dump protection
Jump start protection
Single chip
Internal circuit
Available case sizes:
EIA
0603
0805
1206
1210
1812
2220
Metric
1608
2012
3216
3225
4532
5750
Design
Multilayer technology
Lack of plastic or epoxy encapsulation for
flammability rating better than UL 94 V-0
Termination (see “Soldering directions”):
 CT types with nickel barrier terminations (AgNiSn),
recommended for lead-free reflow and wave
soldering, and compatible with tin/lead solder.
 CN types with silver-palladium terminations
(AgPd) only suitable for reflow and wave soldering
with solder on tin/lead basis and for adhesive
glueing.
V/I characteristics and derating curves
V/I and derating curves are attached to the data sheet.
The curves are sorted by V_RMS and then by case size,
which is included in the type designation.
Please read Cautions and warnings and
Important notes at the end of this document.
Page 3 of 67