OC_LEADED_63V_C_B599_0 Datasheet, PDF (11/15 Pages) EPCOS – PTC thermistors for overcurrent protection

Overcurrent protection
Leaded disks, coated, 63 V
C910 ... C990
Cautions and warnings
General
EPCOS thermistors are designed for specific applications and should not be used for purposes
not identified in our specifications, application notes and data books unless otherwise agreed
with EPCOS during the design-in-phase.
Ensure suitability of thermistor through reliability testing during the design-in phase. The ther-
mistors should be evaluated taking into consideration worst-case conditions.
Storage
Store thermistors only in original packaging. Do not open the package before storage.
Storage conditions in original packaging: storage temperature 25 °C ... +45 °C, relative hu-
midity ≤75% annual mean, maximum 95%, dew precipitation is inadmissible.
Avoid contamination of thermistors surface during storage, handling and processing.
Avoid storage of thermistor in harmful environment with effect on function on long-term opera-
tion (examples given under operation precautions).
Use thermistor within the following period after delivery:
 Through-hole devices (housed and leaded PTCs): 24 months
 Motor protection sensors, glass-encapsulated sensors and probe assemblies: 24 months
 Telecom pair and quattro protectors (TPP, TQP): 24 months
 Leadless PTC thermistors for pressure contacting: 12 months
 Leadless PTC thermistors for soldering: 6 months
 SMDs in EIA sizes 3225 and 4032, and for PTCs with metal tags: 24 months
 SMDs in EIA sizes 0402, 0603, 0805 and 1210: 12 months
Handling
PTCs must not be dropped. Chip-offs must not be caused during handling of PTCs.
Components must not be touched with bare hands. Gloves are recommended.
Avoid contamination of thermistor surface during handling.
Soldering (where applicable)
Use rosin-type flux or non-activated flux.
Insufficient preheating may cause ceramic cracks.
Rapid cooling by dipping in solvent is not recommended.
Complete removal of flux is recommended.
Standard PTC heaters are not suitable for soldering.
Please read Cautions and warnings and
Important notes at the end of this document.
Page 11 of 15