EM47DM1688SBB Datasheet, PDF (6/38 Pages) Eorex Corporation – JEDEC Standard VDD/VDDQ

EM47DM1688SBB
Pin Description (Continued)
C7,B7,F3,G3
J3, K3, L3
DQSU,
DQSU ,
DQSL,
DQSL
RAS ,
CAS , WE
(Data Strobe)
Output with read data, input with write data. Edge-aligned with read data,
centered in write data. DQSL corresponds to the data on DQL0-DQL7;
DQSU corresponds to the data on DQU0-DQU7. The data strobes DQSL,
and DQSU are paired with differential signals DQSU and DQSL
respectively, to provide differential pair signaling to the system during
reads and writes. DDR3 SDRAM supports differential data strobe only and
does not support single-ended.
(Command Inputs)
RAS , CAS & WE (along with CS ) define the command being entered.
D3,E7
D7,C3,C8,C2,A7,
A2,B8,A3
E3,F7,F2,F8,H3,
H8,G2,H7
B2,D9,G7,K2,K9,N
1,N9,R1,R9/A9,B3,
E1,G8,J2,J8,M1,M
9,P1,P9,T1,T9
A1,A8,C1,C9,D2,E
9,F1,H2,H9 /B1,
B9,D1,D8,E2,E8,
F9,G1,G9
L8
DMU,DML
DQU0~7
DQL0~7
VDD/VSS
VDDQ
/VSSQ
ZQ
(Input Data Mask)
DMU & DML are input mask signal for write data. Input data is masked
when DMU or DML are sampled HIGH coincident with that input data
during a write access. DMU & DML is sampled on both edges of DQSU &
DQML respectively.
(Data Input/Output)
Data inputs and outputs are on the same pin.
(Data Input/Output)
Data inputs and outputs are on the same pin.
(Power Supply/Ground)
VDD and VSS are power supply for internal circuits.
(DQ Power Supply/DQ Ground)
VDDQ and VSSQ are power supply for the output buffers.
(ZQ Calibration)
Reference pin for ZQ calibration
(Active Low Asynchronous Reset)
T2
H1
M8
J1,J9,L1,L9,
M7,T7
RESET
VREFDQ
VREFCA
NC
Reset is active when RESET is LOW, and inactive when RESET is
HIGH. RESET must be HIGH during normal operation. RESET is a
CMOS rail to rail signal with DC high and low at 80% and 20% of VDD, i.e.
1.20V for DC high and 0.30V for DC low.
(Reference Voltage)
Reference voltage for DQ
(Reference Voltage)
Reference voltage for CA
(No Connection)
No internal electrical connection is present.
Note: Input pins only BA0-BA2, A0-A13, RAS , CAS , WE , CS , CKE, ODT and RESET do not supply
termination.
Jun. 2012
6/38
www.eorex.com