English
Language : 

EN25Q32B Datasheet, PDF (45/56 Pages) Eon Silicon Solution Inc. – 32 Megabit Serial Flash Memory with 4Kbyte Uniform Sector
EN25Q32B
Table 11. AC Characteristics
(Ta = - 40°C to 85°C; VCC = 2.7-3.6V)
Symbol Alt
Parameter
Min Typ
Max
Serial Clock Frequency for:
FAST_READ, PP, SE, BE, DP, RES, WREN,
D.C.
104
FR
fC
WRDI, WRSR
Serial Clock Frequency for:
RDSR, RDID, Dual Output Fast Read
D.C.
80
fR
Serial Clock Frequency for READ, Quad I/O Fast
Read
D.C.
50
tCH 1
Serial Clock High Time
4
tCL1
Serial Clock Low Time
4
tCLCH2
Serial Clock Rise Time (Slew Rate)
0.1
tCHCL 2
Serial Clock Fall Time (Slew Rate)
0.1
tSLCH
tCSS CS# Active Setup Time (Relative to CLK)
5
tCHSH
CS# Active Hold Time (Relative to CLK)
5
tSHCH
CS# Not Active Setup Time (Relative to CLK)
5
tCHSL
CS# Not Active Hold Time (Relative to CLK)
5
tSHSL
tCSH
CS# High Time for read
CS# High Time for program/erase
15
50
tSHQZ 2
tDIS Output Disable Time
6
tCLQX
tHO Output Hold Time
0
tDVCH
tDSU Data In Setup Time
2
tCHDX
tDH Data In Hold Time
5
tCLQV
tV
Output Valid from CLK
8
tWHSL3
Write Protect Setup Time before CS# Low
20
tSHWL3
Write Protect Hold Time after CS# High
100
tDP 2
CS# High to Deep Power-down Mode
3
tRES1 2
CS# High to Standby Mode without Electronic
Signature read
3
tRES2 2
CS# High to Standby Mode with Electronic
Signature read
1.8
tW
Write Status Register Cycle Time
15
50
tPP
Page Programming Time
1.3
5
tSE
Sector Erase Time
0.09
0.3
tBE
Block Erase Time
0.5
2
tCE
Chip Erase Time
25
50
Note: 1. tCH + tCL must be greater than or equal to 1/ fC
2. Value guaranteed by characterization, not 100% tested in production.
3. Only applicable as a constraint for a Write status Register instruction when Status Register Protect Bit is set at 1.
Unit
MHz
MHz
MHz
ns
ns
V / ns
V / ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
µs
µs
µs
ms
ms
s
s
s
This Data Sheet may be revised by subsequent versions
45
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. D, Issue Date: 2011/07/07
www.eonssi.com