EN25Q16A Datasheet, PDF (14/53 Pages) Eon Silicon Solution Inc. – 16 Megabit Serial Flash Memory with 4Kbyte Uniform Sector

EN25Q16A
Reset-Enable (RSTEN) (66h) and Reset (RST) (99h)
The Reset operation is used as a system (software) reset that puts the device in normal operating
Ready mode. This operation consists of two commands: Reset-Enable (RSTEN) and Reset (RST).
To reset the EN25Q32B the host drives CS# low, sends the Reset-Enable command (66h), and drives
CS# high. Next, the host drives CS# low again, sends the Reset command (99h), and drives CS# high.
The Reset operation requires the Reset-Enable command followed by the Reset command. Any
command other than the Reset command after the Reset-Enable command will disable the Reset-
Enable.
A successful command execution will reset the Status register to data = 00h, see Figure 6 for SPI Mode
and Figure 6.1 for Quad Mode. A device reset during an active Program or Erase operation aborts the
operation, which can cause the data of the targeted address range to be corrupted or lost. Depending
on the prior operation, the reset timing may vary. Recovery from a Write operation requires more
software latency time ( t_SR) than recovery from other operations.
Figure 6. Reset-Enable and Reset Sequence Diagram
Figure 6.1 . Reset-Enable and Reset Sequence Diagram under EQPI Mode
This Data Sheet may be revised by subsequent versions
14
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. E, Issue Date: 2011/07/14
www.eonssi.com