|
EN5396QI Datasheet, PDF (1/19 Pages) Enpirion, Inc. – 9A Synchronous Buck PWM DC-DC Converter with Integrated Inductor External Output Voltage Programming | |||
|
EN5396QI
9A Synchronous Buck PWM DC-DC
Converter with Integrated Inductor
External Output Voltage Programming
RoHS Compliant
Description
The EN5396QI is a Power Supply on a Chip
(PwrSoC) DC-DC converter. It is specifically
designed to meet the precise voltage and fast
transient requirements of present and future
high-performance, low-power processor, DSP,
FPGA, ASIC, memory boards, and system level
applications in a distributed power architecture.
Advanced circuit techniques, ultra high switching
frequency, and innovative, high-density,
integrated circuit and proprietary inductor
technology deliver high-quality, ultra compact,
non-isolated DC-DC conversion. Operating this
converter requires as few as five external
components that include small value input and
output ceramic capacitors and a soft-start
capacitor.
The Enpirion solution significantly helps in
system design and productivity by offering greatly
simplified board design, layout and
manufacturing requirements. In addition, a
reduction in the number of vendors required for
the complete power solution helps to enable an
overall system cost savings.
Applications
⢠Point of load regulation for low-power
processors, network processors, DSPs,
FPGAs, and ASICs
⢠Notebook computers, servers, workstations
⢠Broadband, networking, LAN/WAN, optical
⢠Low voltage, distributed power architectures
with 2.5V, 3.3V or 5V rails
⢠DSL, STB, DVR, DTV, Industrial PC
⢠Noise sensitive applications
Ordering Information
Part Number
EN5396QI-T
EN5396QI-E
Temp Rating (°C)
Package
-40 to +85
58-pin QFN T&R
QFN Evaluation Board
Features
10mm
12mm
⢠Integrated Inductor Technology: Integrated
Inductor, MOSFETS, Controller in a 10 x 12 x
1.85mm package
⢠Low External Part Count.
⢠Up to 30W continuous output power.
⢠Low output impedance optimized for ⤠90 nm
⢠Master/slave configuration for paralleling.
⢠5MHz operating frequency.
⢠High efficiency, up to 93%.
⢠Wide input voltage range of 2.375V to 5.5V.
⢠External resistor divider output voltage select.
⢠Output Enable pin and Power OK signal.
⢠Programmable soft-start time.
⢠Adjustable over-current protection.
⢠Thermal shutdown, short circuit, over-voltage
and under-voltage protection.
⢠RoHS compliant, MSL level 3, 260C reflow.
Typical Application Circuit
VIN
2 x 47µF
1⦠PVIN VOUT
AVIN
ENABLE
XOV
PGND XFB
SS
15nF
VOUT
2 x 47µF
AGND PGND
Figure 1. Simple Layout.
©Enpirion 2009 all rights reserved, E&OE
02393
1
11/12/2009
www.enpirion.com
Rev:C
|
▷ |