EM3027_13 Datasheet, PDF (1/28 Pages) EM Microelectronic - MARIN SA – Real Time Clock with I2C or SPI, Crystal Temperature Compensation, Battery Switchover and Trickle Charger

EM MICROELECTRONIC - MARIN SA
EM3027
Real Time Clock with I2C or SPI, Crystal Temperature
Compensation, Battery Switchover and Trickle Charger
Description
The EM3027 is an Ultra Low Power CMOS real-time
clock IC with two serial interface modes: I2C or SPI. The
interface mode is selected by the chip version (see §12).
The basic clock is obtained from the 32.768 kHz crystal
oscillator. A thermal compensation of the frequency is
based on the temperature measurement and calculation
of the correction value. The temperature can be
measured internally or be input by an external application
to the register.
The chip provides clock and calendar information in BCD
format with alarm possibility. The actual contents are
latched at the beginning of a read transmission and
afterwards data are read without clock counter data
corruption.
An integrated 16-bit timer can run in Zero-Stop or Auto-
Reload mode.
An interrupt request signal can be provided through
INT/IRQ pin generated from alarm, timer, voltage
detector and Self-Recovery system.
An integrated trickle charger allows recharging backup
supply VBack from the main supply voltage VCC through
internal resistor(s). The internal device supply will
switchover to VCC when VCC is higher than VBack and vice
versa.
The device operates over a wide 1.4 to 5.5V supply
range and requires only 900 nA at 5V. It can detect
internally two supply voltage levels.
Applications
 Utility meters
 Battery operated and portable equipment
 Consumer electronics
 White/brown goods
 Pay phones
 Cash registers
 Personal computers
 Programmable controller systems
 Data loggers
Features
 Fully operational from 2.1 to 5.5V
 Supply current typically 600 nA at 1.4V
 Thermal compensated crystal frequency
 Oscillator stability 0.5 ppm / Volt
 Counter for seconds, minutes, hours, day of week,
date months, years in BCD format and alarm
 Leap year compensation
 16-bits timer with 2 working modes
 Two low voltage detection levels VLow1, VLow2
 Automatic supply switchover
 Serial communication via I2C (I²C-bus specification
Rev. 03 compatible – see §10.2) or SPI (3-line SPI-
bus with separate combinable data input and output)
 Thermometer readable by the host
 Trickle charger to maintain battery charge
 Integrated oscillator capacitors
 Two EEPROM and 8 RAM data bytes for application
 Digital Self-Recovery system
 No busy states and no risk of corrupted data while
accessing
 One hour periodical configuration registers refresh
 Support for standard UL1642 for Lithium batteries
 Standard temperature range: -40°C to +85°C
 Extended temperature range: -40°C to +125°C
 Packages: TSSOP8, TSSOP14, SO8.
Block Diagram
EM3027
X1
X2
VCC
VREG
VBack
SCL/SCK
SDA/SO
SI
CS
CLKOUT
INT or IRQ
CLKOE
Temperature
Sensor
Oscillator
Power
Management
I2C
or SPI
Output
Control
Watch & Alarm
- Seconds
- Minutes
- Hours
- Days
- Weekdays
- Months
- Years
Timer
EEPROM
Copyright  2013, EM Microelectronic-Marin SA
1
3027-DS.doc, Version 8.0, 25-Jan-13
www.emmicroelectronic.com