TLP150CJ Datasheet, PDF (1/2 Pages) Emerson Network Power – TLP150CJ will fit the TLP150 power supplies

Embedded Power for
Business-Critical Continuity
TLP150CJ
Enclosure
Installation Notes
TLP150CJ • Cover Accessory Kit
TLP150CJ will fit the TLP150 power supplies.
6-32 PAN HEAD SCREW
WITH WASHER
0.25 LONG (4X)
COVER
Rev. 09.04.07
TLP150CJ Enclosure
1 of 2
INSULATOR
Materials
1 Base
1 Cover
4 M3X6mm Pan head screws
with spring washer
4 M3X6mm countersunk
screws
1 M4 nut
1 M4 star washer
1 M4 spring washer
1 Plastic insulator sheet
CHASSIS
4-40 C'SINK SCREW
WITH 0.25 LONG (4X)
Installation Instructions and Notes
1. Place the insulator over the chassis as shown.
2. Place TLP150 power supply over the insulator as shown.
3. Align the 4x power supply to the chassis standoff.
4. Secure 4 pan head screws with washer provided with in kit as shown.
5. Place the cover over TLP150 power supply as shown.
6. Align the 4x cover to the U-bracket countersink holes.
7. Secure 4 countersink screws provided with in kit as shown.
8. Overall dimensions: 5.95 (151.13) x 3.4 (86.36) x 1.6 (40.64).
9. Base plate has two sets of customer mountings:
a. Bottom mounting (4X) M3 inserts. Max. screw penetration 0.0787 (2mm)
b. Side mounting (4X) M3 inserts. Max. screw penetration 0.236 (6mm)
10. Ensure insulator is correctly fitted in base under PCB to maintain safety creepage
and clearances.
11. Ensure base is firmly connected to supply earth via the earth stud marked
12. When using this enclosure, ensure that relevant safety standards (e.g. EN60950) are com-
plied with, in respect to creepage and clearance distances, and distances through insulation.
13. All dimensions are in inches (mm)