DPS50 Datasheet, PDF (1/2 Pages) Astec America, Inc – DPS50 Series

Embedded Power for
Business-Critical Continuity
DPS50
60 Watts
Total Power:
Input Voltage:
# of Outputs:
30 - 60 Watts
90 - 264 VAC
127 - 300 VDC
Single
Rev. 10.01.08_122
DPS50
 of 2
RoHS
Special Features
• CE Mark EMC & LVD
• Universal AC input
• Fully regulated output
• Overload and short circuit
protection
• Internal remote sense to the
output plug
• Constant voltage
• High efficiency
• High MTBF
• IEC320 AC receptacle, 3 pin
(type C14)
• Built in EMI filter
(CISPR 22 Class B)
• LED power good indicator
• Input power <74 watts
• Complies with EN61000-3-2
• Meets Energy Star
• WEEE & CeC IV compliant
Safety
UL
UL 60950-1
CSA CSA-C22.2 no.60950-1
VDE EN60950-1
CE
EMC & LVD
CB
Certificate and report
PSE Denan 06-03051012
Electrical Specifications
Input
Input ra­nge
Frequency
Inrush current
Input current
Efficiency
EMI/RFI
Safety ground
leakage current
Output
Maximum Power (Po)
Hold-up time
Overvoltage protection
Overload protection
Cable/connector
90-264 VAC (wide range)
127 - 300 VDC
47-440 Hz
<60A @ 230 VAC, cold start @ 25C
<2.0A rms @ 115 VAC; <1A @ 230 VAC
80% @ full load typical, @115VAC
FCC Part 15, Subpart B Class B & EN55022 (CISPR 22) Class B
0.5mA @ 50/60 Hz, 264 VAC input
60W (DPS52, 30W)
10ms. typical at full load @ 115VAC
20% - 45% above nominal output maximum
Latching type, recycle AC to reset.
Output short circuit protection auto recover
Overload protected @ 120 - 150% above maximum rating
DC cable with 2.5mm center plug
DC plug center +v
DC plug outer -v
Environmental Specifications
Operating temperature: 0° to +40°C ambient. Derate each output as 2.5% per degree from
40°C to 60°C. -20°C start up
Storage temperature: -40°C to +85°C
Electromagnetic
Designed to meet EN61000-4, -2, -3, -4, -5, -6, -8, -11, level 3
susceptibility:
Humidity:
Vibration:
Operating; non-condensing 10% to 90% RH
Three orthogonal axes, 3 sweeps per axe at 1 oct/min. 2G peak 8Hz
to 500Hz, operational
MTBF demonstrated: >550,000 hours at full load and 25°C ambient conditions