OPTIVA-OTS-ODLS-I-40GHZ Datasheet, PDF (2/3 Pages) Emcore Corporation – Internal Fiber Delay Line System

Optiva OTS-ODLS 40 GHz, 40 µs max
Internal Fiber Delay Line System
DATASHEET | APRIL 2014
Specifications
Typical RF Characteristics/Standard Features measured with OTS-2 Tx and OTS-2 Rx
Parameter
Value
Unit
Comments
Frequency Range
0.05-40
GHz
Delay Range
3 to >40
msec
Delay Tolerance
< +/-2
%
Phase Stability
rφ < 2^o per 10 sec
--
Typical for 40 ms DLS
RF Input Level
0 to 16
dBm
Typical
Deviation from Linear Phase
< 10°
--
Typical (up to 40 GHz)
Amplitude Flatness
< +/-3
dB
Amplitude Linearity
< +/-1
dB
Gain (@ RF in = 0 dBM)*
< -20
dB
Return Loss/VSWR
R_L > 15
dB
< 1.43:1
Spur Level
< -60
dBc
Input 1 dB Compression Point
> +16
dBm
2nd Harmonic (@ RF_in = 0 dBm)
Noise Figure
< -45
dBc
< 70
dB
RF Connectors
SMA-K
--
Typical
*0 dB gain is based upon a single 40 µs delay spool and receiver with 35 dB post amplifier. Actual system gain will vary based upon
system requirements.
Environmental Specifications
Parameter
Symbol
Min
Operating Temperature
T_OP
-10
Operating Humidity, Maximum Non-Condensing
-
-
Operating Altitude, Above Sea Level
-
-
Storage Temperature
T_STG
-40
Storage Humidity, Maximum Non-Condensing
-
-
Storage Altitude, Above Sea Level
-
-
Max
50
95
6000
1828
70
95
50,000
15,240
Units
°C
%
ft
m
°C
%
ft
m
Block Diagram - Four Delays System Option
MICROWAVE
Enclosure Options
OT-CC-16F
Power Consumption - Max
Model
OTS-ODLS-I
Input Voltage
(VAC)
120 / 240
Wattage
(@+50°C)
200 W
Delay Value 1 = IN1OUT1IN2OUT2
Delay Value 2 = IN1DELAY1OUT1IN2OUT2
Delay Value 3 = IN1OUT1IN2DELAY2OUT2
Delay Value 4 = IN1DELAY1OUT1IN2DELAY2OUT2
Other delay configurations available
© 2014 EMCORE Corporation | REV 2014.04
[phone]
[e-mail]
www.emcore.com
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.