6000-0ID1-11001_13 Datasheet, PDF (2/6 Pages) Emcore Corporation – I-Type Medallion 6000 1550 nm Externally-Modulated Transmitter

I-Type Medallion 6000 1550 nm
Externally-Modulated Transmitter
DATASHEET | NOVEMBER 2013
FIBER OPTICS
Optical Characteristics
Property
Performance (note 1-9)
Specified Link Length
Channel Plan
Units
L (km)
6000-0IE1
65
NTSC 80-Ch
65
PAL 60-Ch
Comments
Other Fiber Lengths Supported. See
Note 8
Other Channel Plans Supported. Note 9
Optical Output Power
Po (dBm)
7.0/7.0
8.5/8.5
Min. 10 dBm version avail. See Chart
Noise Bandwidth
BW (MHz)
4
5
SBS Suppression
(dBm)
13 to 19
13 to 19
Min.
Carrier to Noise Ratio
CNR (dB)
52.5
52.5
Min.
Composite Second Order
CSO (dBc)
-65
-65
Max. Port 1
Composite Triple Beat
CTB (dBc)
-65
-65
Max. @ +25C
Composite Triple Beat
CTB (dBc)
-64
-64
Max. @ 0^oC to 50^oC
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization period.
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2
8. Fiber lengths from 0 to 100 km can be supported. See Figure 2 for CSO performance.
9. The lowest frequency of all channel plans shall be > 119.25 MHz. A 2 dB penalty of CNR may occur for channels from 85 to 112.25
MHz. See the Electrical Specifications Table for correct input power for other channel plans.
Test/Link Configuration
I-Type
Property
Figure 1
EDFA
16 dBm
Link
65 Km
Received Power²
0.0 dBm at the receiver
| REV 2013.11
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.