5021TR-B Datasheet, PDF (2/4 Pages) Emcore Corporation – 5021TR-B 7 GHz 1310 nm DFB Transceiver

5021TR-B 7 GHz 1310 nm
DFB Transceiver
DATASHEET | AUGUST 2013
MICROWAVE
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings
only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operation-
al sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability.
Parameter
Symbol Condition Min Max Unit
Operating Temperature Range of Baseplate
T_OP
continuous -40
+65
˚C
Storage Temperature
T_STG
-
-55 +85
˚C
RF Input Power
P_IN
60 seconds
-
20
dBm
Electrical Characteristics
Parameter
5021TR-B
Unit
Upper Band Edge Frequency, min
7
GHz
Lower Band Edge Frequency, max
0.05
GHz
Amplitude Flatness, max³
4.0
dB p-p
Transmitter Gain (TG), 1 GHz²
-17
db (W/A)
Receiver Gain (RG), 1 GHz²
-11
db (A/W)
Input RF Return Loss, max³
0.05 GHz - 7.0 GHz
-7.0
dB
Output RF Return Loss , max
0.05 GHz - 7.0 GHz
-9.0
dB
Impedance, typ
50
Ohm
Input 1 dB Compression, min³
+20
dBm
Input Third Order Intercept³
0.05 GHz – 7.0 GHz
+30
dBm
Noise Figure, max3
0.05 GHz - 3.0 GHz
3 GHz - 7.0 GHz
44
dB
50
dB
1. Tested at 25°C unless noted otherwise.
2. Link RF Gain_dB = TG + RG-2* FiberLoss_dB(assumes R_IN = R_OUT)
3. Performance applies only within frequency band specified by the model number.
Optical Characteristics
Parameter
Fiber
Optical Connectors
5021 Optical Transmitter Output Power
Optical Receiver Input Power
Delay - Tx Optical
Delay - Rx Optical
Specifications
Single mode (9/125)
SC/APC or FC/APC
9 to 11
10
7.5
7.5
Unit
µm
-
dBmo
dBmo, max
ns, max
ns, max
DC Interface Characteristics
Pin Number
Min
Typ
Max
1
11 V
16 V
2
4.5 V
5.5 V
Max Ripple
100 mV p-p
200 mV p-p
Current
0.3 A max
1.6 A max
© 2013 EMCORE Corporation | REV 2013.08
[phone]
[e-mail]
www.emcore.com
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.