MAFA-2100-PA1 Datasheet, PDF (1/3 Pages) Emcore Corporation – Micro Erbium Doped Fiber pre-Amplifier

MAFA 2100 PA Series EDFA
Micro Erbium Doped Fiber pre-Amplifier
DATASHEET | DECEMBER 2013
Applications
High-Performance Supertrunking Links
High Power Distribution Networks
Redundant Ring Architectures
FTTx Networks
Features
Fully Functioning EDFA Gain Block
(preamp)
Standard RS-232 Communication
Low Electrical Power Consumption
Output Isolation >40 dB
Polarization Dependent Gain <0.1 dB
Polarization Mode Dispersion <0.5 ps
FIBER OPTICS
EMCORE’s MAFA 2100 PA Series Micro Erbium Doped Fiber pre-Amplifier is an ideal
building block for OEM system integrators. The family of MAFA 2100 PA series preamps
is designed to meet the most demanding noise performance requirements of any fiber link
application, and perform all the functions required of an optical preamplifier for system
integration. The MAFA 2100 PA series provides optical isolation on the output of the gain
block for stable, low noise operation. The output optical signal power levels are detected
for monitoring and control. The MAFA 2100 PA series also provides monitors and
associated alarms for all vital characteristics.
Optical/Electrical Characteristics¹
Property
Operating Input Power
Unit
Pin (dBm)
Limit
Max
Model - 2114 PA
0
Comments
-
Operating Input Power Pin (dBm)
Min
-45
-
Saturated Output
Power
Po(dBm)
Min
14
(note 3)
Operating Wavelength
Range
Noise Figure
Nm
NF (dB)
Min/Max
Max
1530 – 1562
3.3
Nominal
(note 2)
Power Consumption
Psys (W)
Max
8
+85^oC Case
Notes:
1. Unless stated otherwise all specifications apply over the full temperature range and
humidity.
2. Measured @ 1550 nm, Pin -30 dBm and @ 25^°C
3. Measured @ Pin = -4 dBm
| REV 2013.12
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.