359C Datasheet, PDF (1/2 Pages) Emcore Corporation – Dispersion Compensation Module

359C Series 1550 nm
Dispersion Compensation Module
DATASHEET | NOVEMBER 2014
MICROWAVE
Applications
„„ Radar Testing/Calibration
„„ Signal Processing
„„ Phased Array Antennas
„„ Phase Noise Processing
„„ Antenna Site Diversity
The 359C Series Dispersion Compensation Module provides a solution for deal-
ing with existing high dispersion legacy installations. By providing a negative
dispersion, fiber with high positive dispersion can be fully compensated. Typical
dispersion compensation modules can increase the total fiber length by as much
as 65%, while these highly efficient high dispersion fibers only increase the total
fiber length of the system by approximately 13%. Thus lessening the requirement
on the EDFA modules required to compensate for the total fiber loss.
The 359X platform works with a wide range of fiber optic transport products for
satellite and microwave communications from 1 MHz to 40 GHz. These units can
be used to construct transparent inter- and intra-facility links from 1 meter to
>100 km for RF and microwave signal transport, antenna remoting, video trans-
port, electronic warfare systems and other high-dynamic-range applications.
Delay Length & Dispersion Specifications
Product
359C
Size
Max Delay Max. Length
1 RU
110 µs
24 km
Note: Max length of SMF-28 brought to 0 dispersion is 183.4 km.
Total Dispersion
-1.6*10⁵ ps/nm
Features
„„ Delays Up to 110 microseconds
„„ 24 KM
„„ Small Size
„„ Flat RF Amplitude Response and Phase
Optical Specifications
Parameter
Attenuation @ 1550 nm
IOR @ 1550 nm
Typical Total Dispersion @ 1550 nm
Typical
< 0.25
1.469
-130
Units
dB/km
ps/nm-km
© 2014 EMCORE Corporation | REV 2014.11
[phone]
[e-mail]
www.emcore.com
Information contained herein is deemed to be reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specifications at any time without notice.