MC-4516CA727 Datasheet, PDF (6/16 Pages) NEC – 16M-WORD BY 72-BIT SYNCHRONOUS DYNAMIC RAM MODULE UNBUFFERED TYPE

MC-4516CA727
DC Characteristics (Recommended Operating Conditions Unless Otherwise Noted)
Parameter
Symbol
Test condition
MIN. MAX. Unit Notes
Operating current
ICC1 _{Burst length = 1}
tRC ≥ tRC(MIN.), IO = 0 mA
/CAS latency = 2
/CAS latency = 3
900 mA 1
945
Precharge standby current in ICC2P CKE ≤ VIL(MAX.), tCK = 15 ns
9 mA
power down mode
ICC2PS CKE ≤ VIL(MAX.), tCK = ∞
9
Precharge standby current
in non power down mode
Active standby current in
ICC2N CKE ≥ VIH(MIN.), tCK = 15 ns, /CS ≥ VIH(MIN.),
Input signals are changed one time during 30 ns.
ICC2NS CKE ≥ VIH(MIN.), tCK = ∞
Input signals are stable.
ICC3P CKE ≤ VIL(MAX.), tCK = 15 ns
180 mA
72
45 mA
power down mode
ICC3PS CKE ≤ VIL(MAX.), tCK = ∞
36
Active standby current in
non power down mode
ICC3N CKE ≥ VIH(MIN.), tCK = 15 ns, /CS ≥ VIH(MIN.),
Input signals are changed one time during 30 ns.
270 mA
ICC3NS CKE ≥ VIH(MIN.), tCK = ∞,
Input signals are stable.
Operating current (Burst mode) ICC4 tCK ≥ tCK(MIN.), IO = 0 mA
/CAS latency = 2
180
1,080 mA 2
/CAS latency = 3
1,395
CBR (Auto) refresh current
ICC5 tRC ≥ tRC(MIN.)
/CAS latency = 2
2,070 mA 3
/CAS latency = 3
2,160
Self refresh current
ICC6 CKE ≤ 0.2 V
18 mA
Input leakage current
II(L) VI = 0 to 3.6 V, All other pins not under test = 0 V
– 9 + 9 µA
Output leakage current
IO(L) DOUT is disabled, VO = 0 to 3.6 V
– 1.5 + 1.5 µA
High level output voltage
VOH IO = – 4 mA
2.4
V
Low level output voltage
VOL IO = + 4 mA
0.4 V
Notes 1. ICC1 depends on output loading and cycle rates. Specified values are obtained with the output open. In
addition to this, ICC1 is measured on condition that addresses are changed only one time during tCK (MIN.).
2. ICC4 depends on output loading and cycle rates. Specified values are obtained with the output open. In
addition to this, ICC4 is measured on condition that addresses are changed only one time during tCK (MIN.).
3. ICC5 is measured on condition that addresses are changed only one time during tCK (MIN.).
6
Data Sheet E0056N20