GD25Q32C Datasheet, PDF (38/50 Pages) ELM Electronics – 32M-bit Serial Flash

GD25Q32CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
7.33. Enable Reset (66H) and Reset (99H)
http://www.elm-tech.com
If the Reset command is accepted, any on-going internal operation will be terminated and the device will
return to its default power-on state and lose all the current volatile settings, such as Volatile Status Register bits,
Write Enable Latch status (WEL), Program/Erase Suspend status, Read Parameter setting (P7-P0), Continuous
Read Mode bit setting (M7-M0) and Wrap Bit Setting (W6-W4). The “Reset (99H)” command sequence as
follow: CS# goes low → Sending Enable Reset command → CS# goes high → CS# goes low → Sending
Reset command → CS# goes high. Once the Reset command is accepted by the device, the device will take
approximately tRST=60µs to reset. During this period, no command will be accepted. Data corruption may
happen if there is an on-going or suspended internal Erase or Program operation when Reset command sequence
is accepted by the device. It is recommended to check the BUSY bit and the SUS bit in Status Register before
issuing the Reset command sequence.
Figu_Fr_ie_gu3_r8_e.₃E_8.n_Ea_nb_al_be_leR_Re_es_se_et_ta_an_nd_d R_Ree_ss_ee_tt_cc_oo_mm_mm_ana_dnd_SeS_qe_uq_enu_ce_enc_De_iaD_gri_aa_mgram
7.34. Read Serial Flash Discoverable Parameter (5AH)
7.34. Read Serial Flash Discoverable Parameter (5AH)
The Serial Flash Discoverable Parameter (SFDP) standard provides a consistent method of describing the
functional and feature capabilities of serial flash devices in a standard set of internal parameter tables. These
parameter tables can be interrogated by host system software to enable adjustments needed to accommodate
divergent features from multiple vendors. The concept is similar to the one found in the Introduction of JEDEC
Standard, JESD68 on CFI. SFDP is a standard of JEDEC Standard No.216.
Figure_Fig3_u9_r._eR₃e₉a_{. R}d_eS_ae_dr_Sia_el_riF_alla_Fs_lah_shD_Dis_isc_co_ov_ve_er_ra_ab_bll_ee_PP_aa_rr_aa_mm_ete_et_re_cr_oc_mo_mm_am_ndan_Sd_eqS_ue_eq_ncu_een_Dc_iae_gD_ramiagram
50 - 38
Rev.1.0