GD25Q80CXIGX Datasheet, PDF (30/49 Pages) ELM Electronics – 3.3V Uniform Sector Dual and Quad Serial Flash

GD25Q80CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
7.22. Read Manufacture ID/Device ID (REMS) (90H)
http://www.elm-tech.com
The Read Manufacturer/Device ID command is an alternative to the Release from Power-Down/Device ID
command that provides both the JEDEC assigned Manufacturer ID and the specific Device ID.
The command is initiated by driving the CS# pin low and shifting the command code “90H” followed by a
24-bit address (A23-A0) of 000000H. After which, the Manufacturer ID and the Device ID are shifted out on
the falling edge of SCLK with most significant bit (MSB) first as shown in Figure27. If the 24-bit address is
initially set to 000001H, the Device ID will be read first.
Figure 27. Read Manufacture ID/Device ID Sequence Diagram
7.23. Read Identification (RDID) (9FH)
The Read Identification (RDID) command allows the 8-bit manufacturer identification to be read, followed by
two bytes of device identification. The device identification indicates the memory type in the first byte, and the
memory capacity of the device in the second byte. The Read Identification (RDID) command while an Erase
or Program cycle is in progress is not decoded, and has no effect on the cycle that is in progress. The Read
Identification (RDID) command should not be issued while the device is in Deep Power-Down Mode.
The device is first selected by driving CS# to low. Then, the 8-bit command code for the command is shifted
in. This is followed by the 24-bit device identification, stored in the memory, being shifted out on Serial Data
Output, each bit being shifted out during the falling edge of Serial Clock. The command sequence is shown in
Figure28. The Read Identification (RDID) command is terminated by driving CS# to high at any time during
data output. When CS# is driven high, the device is put in the Standby Mode. Once in the Standby Mode, the
device waits to be selected, so that it can receive, decode and execute commands.
49 - 30
Rev.1.4