|
ELM627 Datasheet, PDF (1/4 Pages) ELM Electronics – RS232 Break Detector | |||
|
ELM627
RS232 Break Detector
Description
The ELM627 is a complete circuit for detecting
break signals on RS232 lines, in an 8 pin package.
This is useful for remotely resetting circuits through a
serial link. For convenience, this circuit also
generates an output pulse on power-up.
The timing threshold for break signal detection is
user selectable, allowing the circuit to respond to
transmitted null characters, <ctrl>@, at various baud
rates. This provides a convenient means for the
remote triggering of this circuit by simply shifting to a
lower baud rate and sending a null byte.
Two complementary high current outputs are
provided by the ELM627, so that further buffering is
not usually required. The output signal can be
selected to be either a continuous one (following the
TxD input line) or else a 100ms pulse output.
No external components are required for circuit
operation other than possibly a current limiting
resistor, as all timing references are generated
internally.
Applications
⢠Remote resetting of RS232 devices
⢠Edge triggered one-shot circuits
⢠Digitally controlled sequencing schemes
⢠Watchdog type signal monitors
Features
⢠Low power CMOS design - typically 1mA at 5V
⢠No external timing elements required
⢠Complementary outputs
⢠Digitally controlled threshold timing
⢠Selectable output duration
⢠High current drive outputs - up to 25 mA
Connection Diagram
PDIP and SOIC
(top view)
VDD 1
Q2
Q3
P/C 4
8 VSS
7 T0
6 T1
5 TxD
Block Diagram
TxD 5
Programmable
Timer
6
7
T1 T0
Power on
Detect
Output
Logic
4
P/C
ELM627DSA
Elm Electronics â Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
2Q
3Q
1 of 4
|
▷ |