SGR282Z Datasheet, PDF (1/1 Pages) ELESTA GmbH – will be replaced by SGR282ZK

relays
SGR 282 Z Series
will be replaced by SGR282ZK
Relay Key Data
Circuit Diagram (view on relay upper side)
Contact Lifetime for NO Contacts
-- PCB Relay with forcibly guided contacts
-- Protective separation between coil and contacts
(leakage and creepage distances >14mm); protective
separation diagonally between left and right contact
side (leakage and creepage distances >5.5mm)
-- EN50205 type B
-- 2 CO contacts
-- Mean coil power 1W
-- Holding coil power 0.31W
Dimensions
30.2
12.7
24 14
21 11
22 12
SGR282Z
A2
A1
Insulation Data
10000
1000
100
10
0.1
0.5 1.0
Switching Current (A)
DC 1:24V
AC 1:230V
AC 15:230V
DC 13:24V
5.0 10
-- Double or reinforced insulation
at 250VAC
Maximal switching characteristics (DIN EN60947-5-1,
Tab. C2)
-- Air and creepage distance
>5.5mm _{AC 15: 230V / 3A}
-- Test voltage
4‘000V/50Hz/1min _{DC 13: 24V / 4A}
2.6 5 5 15 2.6
Ø1.3
2.5/2.54
Contact Data
Contact material
Type of contact
1
7.5
[mm]
AgCuNi
Single contact
-- Double or reinforced insulation
-- Air and creepage distance
at 250VAC
>14mm
UL 508: C300
-- Test voltage
Test voltage contact open
Creepage resistance
Pollution degree
Overvoltage category
Insulation resistance at Up 500VDC
Additional Data
Mechanical endurance
Switching frequency, mechanical
Response time (all NO closed)
designs ^{5‘000V/50Hz/1min}
1‘500V/50Hz/1min
CTI 550
2
III
>100MΩ
>50x10⁶ operations
15Hz
typically 12ms
Maximal contact load at AC 1 with 230V:
2 contacts with 6A each
Gold contacts with 4-6μm layer thickness
When switching high voltages and currents the layer of
gold is already destroyed after a few switching ope-
rations. Once the gold layer is damaged due to the
switching of high loads, this contact must not be used
anymore for signal and control current circuits.
Then safe contact making is only possible at high loads
with the formation of sparks.
Not ^{for new Rated switching capacity}
250VAC 6A AC1 2‘000VA
Electr. life AC 1(360 cycles/h)
approx.100‘000
Inrush current max.
15A for 20ms
Switching voltage range
5 to 250 VDC/VAC
Switching current range*
20mA to 6A
Switching current range**
10mA to 6A
Switching capacity range*
120mW to 1‘500W(VA)
Switching capacity range**
60mW to 1‘500W(VA)
Contact resistance (as delivered) ≤100mΩ/28V/100mA
*Guided values
**Values for AgCuNi+4-6μm Au
Standard coils for direct current
(other voltages on request)
Drop-out time** (all NC closed)
typically 5ms
Bounce time of NO contact
typically 4ms
Bounce time of NC contact
typically 8ms
Shock resistance 16ms
NO > 10g
NC > 2.5g
Vibration resistance
NO > 10g
(10-55Hz)
NC > 1g
Resistance to short circuiting contacts
1‘000A SCPD 6A gG/gL (pre-fuse)
Ambient temperature
-40°C to +70°C
Thermal resistance
50K/W
Temperature limit for coil
120°C
Weight
ca. 20g
Mounting position
any
Type of protection
RT II
Load Limit Curve with Direct Current
8
6
4
3
2
1
2
1
0.8
0.6
0.4
0.3
0.2
0.10
50
100 150 200
Switching Current (A)
250
Solder bath temperature
270°C/5s 1) Inductive load L/R 40ms
**without spark suppression
2) Resistive load
Tests, Regulations
Approvals
Excitation Voltage Range
3.0
5
3.75 ≥0.5 181.8
27.5 ± 10%
6
4.5 ≥0.6 166.6
36 ± 10%
12
9.0 ≥1.2 85.7
140 ± 10%
18
13.5 ≥1.8 66.6
270 ± 10%
24
18.0 ≥2.4 33.3
720 ± 10%
48
36.0 ≥4.8 20.8 2‘300 ± 10%
60
45.0 ≥6.0 13.6 4‘400 ± 13%
110
82.5 ≥11.0
11.0 10‘000 ± 15%
UL File E188953
Insulation class IEC 60664-1
Protection class II
Fire protection requirements
Options, Accessories
PCB socket, DIN rail socket
Sealed RT III
Dust resistant with O-Ring
Contact material with 4-6μm Au
Product Key
SGR282Z 24VDC AU6 08
Sec. 1
250VAC
VDE 0106
UL 94 / V1
see page 30
on request
O-ring dust resistant
Gold plating 4-6μm
Coil voltage
Type designation
2.5
2.0
1
1.5
1.0
2
0.5
U_B
U_{N 0}
0
20
40
60
80 100
Ambient Temperature °C
1) Max. excitation voltage with contact load: ≤4A
2) Min. excitation voltage (guaranteed values) without
previous operation
No heat accumulation due to intrinsic heating of
other components. Continuous duty 100%.
ELESTA GmbH, Heuteilstrasse 18, Fon:
CH - 7310 Bad Ragaz, Switzerland Fax:
[phone]
[phone]
© Copyright
05/2014