EL400C Datasheet, PDF (1/11 Pages) Elantec Semiconductor – 200MHz Current Feedback Amplifier

EL400C
200MHz Current Feedback Amplifier
Features
• 200MHz -3dB bandwidth, A_V = 2
• 12ns settling to 0.05%
• V_S = ±5V @ 15mA
• Low distortion: HD2, HD3 @
-60dBc at 20MHz
• Differential gain 0.02% at NTSC,
PAL
• Differential phase 0.01° at NTSC,
PAL
• Overload/short-circuit protected
• ±1 to ±8 closed-loop gain range
• Low cost
• Direct replacement for CLC400
Applications
• Video gain block
• Video distribution
• HDTV amplifier
• High-speed A/D conversion
• D/A I-V conversion
• Photodiode, CCD preamps
• IF processors
• High-speed communications
Ordering Information
Part No.
EL400CN
EL400CS
Temp. Range
-40°C to +85°C
-40°C to +85°C
Package
8-Pin P-DIP
8-Lead SO
Outline #
MDP0031
MDP0027
General Description
The EL400C is a wide bandwidth, fast settling monolithic amplifier
built using an advanced complementary bipolar process. This ampli-
fier uses current-mode feedback to achieve more bandwidth at a given
gain than conventional operational amplifiers. Designed for closed-
loop gains of ±1 to ±8, the EL400C has a 200MHz -3dB bandwidth
(A_V = +2), and 12ns settling to 0.05% while consuming only 15mA of
supply current.
The EL400C is an obvious high-performance solution for video distri-
bution and line-driving applications. With low 15mA supply current,
differential gain/phase of 0.02%/0.01°, and a minimum 50mA output
drive, performance in these areas is assured.
The EL400's settling to 0.05% in 12ns, low distortion, and ability to
drive capacitive loads make it an ideal flash A/D driver. The wide
200MHz bandwidth and extremely linear phase allow unmatched sig-
nal fidelity. D/A systems can also benefit from the EL400C, especially
if linearity and drive levels are important.
Connection Diagrams
DIP and SO Package
Top View
Manufactured under U.S. Patent No. 4,893,091
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.