E11F4 Datasheet, PDF(9/9 Page) Ecliptek Corporation

◁

PART NUMBERING GUIDE

E32F4 F 3 A 2 C - 155.520M - CL125

FREQUENCY TOLERANCE & STABILITY/

OPERATING TEMPERATURE RANGE

D=Â±50ppm Maximum over 0Â°C to +70Â°C

E=Â±25ppm Maximum over 0Â°C to +70Â°C

F=Â±20ppm Maximum over 0Â°C to +70Â°C

H=Â±50ppm Maximum over -40Â°C to +85Â°C

APR

3=Â±50ppm Minimum

LINEARITY

A=20%

B=15%

C=10%

AVAILABLE OPTIONS

Blank=None (Standard)

CLXXX=Custom Lead Length (See Page 153)

G=Full Size Gull Wing (See Page 152)

FREQUENCY

ADDITIONAL OUTPUT

A=No Connect

C=Complementary Output

DUTY CYCLE

1=50 Â±10(%)

2=50 Â±5(%)

NOTES

OBSOLETE __________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

_________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________

MECHANICAL DIMENSIONS

ALL DIMENSIONS IN MILLIMETERS

Pin 1: Voltage Control

Pin 7: Case Ground

Pin 8: Output

Pin 9: Complementary Output or No Connect

Pin 14: Supply Voltage

ENVIRONMENTAL/MECHANICAL SPECIFICATIONS

MARKING SPECIFICATIONS

Line 1: ECLIPTEK

Characteristic

Seal Integrity

Solderability

Marking Permanency

Shock

Vibration

Specification

Bubble test in Perfluorocarbon at +125Â°C Â±5Â°C for 60 seconds

minimum.

Sn63 Solder dip at +230Â°C Â±5Â°C for 5 seconds/95% coverage.

10 Strokes with brush after 1 minute soak in solvent, 3 times.

Random drop on hard wooden plate 3 times from a height

of 20cm.

Frequency with an amplitude of 1.5mm sweeping between 10Hz

to 55Hz within 1 minute (approximately) for 2 hours minimum on

each axis (X, Y and Z) for a total of 6 hours.

Line 2: XX.XXX M

Frequency in MHz

(5 Digits Maximum + Decimal)

Line 3: XX Y ZZ

Week of Year

Last Digit of Year

Ecliptek Manufacturing Identifier

Note: Pin 1 shall be designated with a dot

MANUFACTURER

ECLIPTEK CORP.