EC25C32 Datasheet, PDF (1/16 Pages) E-CMOS Corporation – 32Kbits SPI Serial EEPROM

32Kbits SPI Serial EEPROM
EC25C32
General Description
The EC25C32 is an industrial standard electrically
erasable programmable read only memory
(EEPROM) Product that utilizes standard Serial
Peripheral Interface (SPI) for communications.
The EC25C32 contains a memory array of 32K
bits (4,096x 8), which is organized in 32 bytes per
page.
This EEPROM operates in a wide voltage range
from 1.7V to 5.5V,which fits most application.
The device provides low-power operations and
low standby current. The product is offered in
Lead-free, RoHS, halogen free or Green package.
The available package types are 8-pin SOP,
TSSOP and UDFN.
The functionalities of the EC25C32 are optimized
for most applications, such as consumer
electronics,wireless,telecommunication, industrial,
medical ,instrumentation, commercial and others,
where low-power and low-voltage are vital. This
product has a compatible SPI interface: Chip-
Select ( CS ), Serial Data In (SI), Serial Data Out
(SO) and Serial Clock (SCK) for high-speed
communication. Furthermore, a Hold feature
via HOLD pin allows the device entering into
a suspended state whenever necessary and
resuming the communication without re-initializing
the serial sequence. A
Status Register
facilitates a flexible write protection mechanism
and device Status monitoring.
In order to refrain the state machine from entering into a
Wrong state during power-up sequence or a power
toggle off-on condition, a power on reset circuit is
implemented. During power-up, the device does not
respond to any instructions until the supply voltage
(VCC)has reached an acceptable stable level above the
reset threshold voltage. Once VCC passes the power on
reset threshold, the device is reset and enters into
Standby mode. This should also avoid any inadvertent
Write operations during power-up stage. During power-
down process, the device will enter into standby mode,
once VCC drops below the power on reset threshold
voltage. In addition, the device will be in standby mode
after receiving the Stop command, provided that no
internal write operation is in progress. Nevertheless,
it is illegal to send a command unless the VCC is within its
operating level.
E-CMOS Corp. (www.ecmos.com.tw)
Page 1 of 16
5F09N-Rev.F001