DSU0805C101JN Datasheet, PDF (5/6 Pages) Dubilier – SURFACE MOUNT CERAMIC SURFACE MOUNT MULTI - LAYER DS

SURFACE MOUNT
CERAMIC SURFACE MOUNT MULTI - LAYER DS
PERFORMANCE CHARACTERISTICS
PERFROMANCE CHARACTERISTICS
1. ELECTRICAL
Dielectric Code
COG
General
COG dielectrics are very
stable. Temperature, fre-
quency and time vary little.
Examples of Applications
Typical applications are
in tuned circuits, timing
circuits and fast rise time
circuits.
Temperature Range
Insulation Resistance (I.R.)
after 1 min charging at
Rated Voltage
Voltage Ratings dc
- 55° to + 125°
> 100G ohms or 1000 sec
whichever is less
50, 100, 200, 500
Proof Voltage
Max allowable Capaci-
tance
Variation over Temperature
Range
2.5 x rated voltage
C > 20pf : 0 ± 00ppm/°C
C < 20pF : see CECC 32
101-801
X7R
X5R
Y5V
Z5U
X7R dielectrics offer higher X5R dielectrics offer higher Y5V dielectrics offer the Z5U dielectrics offer the
capacitance for a given capacitance for a given highest capacitance for highest cpacitance for a
case size than COG.
case size than X7R.
a given case size than X5R. given case size than Y5V.
Applications would include
bypass, coupling and filter-
ing circuits.
Applictaions would include
bypass, coupling and filter-
ing circuits.
Applications would include
bypass and decoupling
circuits or where tempera-
ture dependence is not of
major importance.
Applications would include
bypass and decoupling
circuits or where tempera-
ture dependance is not of
major importance.
-55° to + 125°
- 55° to + 85°
- 25° to + 85°
- 25° to + 85°
>100G ohms or 1000 sec >100G ohms or 1000sec >10G ohms or 100 sec
whichever is less
whichever is less.
whichever is less.
>10G ohms or 100 sec
whichever is less.
10, 16, 25, 50, 100, 200,
500
2.5 x rated voltage
± 15%
10,16,25,50
2.5 X rated voltage.
± 15%
10, 16, 25, 50, 100
2 x rated voltage
+30% to - 80%
25, 50
2.5 x rated voltage
+22% to - 56%
2. ENVIRONMENT
Test
Resistance to soldering
heat
Adhesion
Rapid change or Tem-
perature
Conditions
Components completely
immersed in a solder bath
at 260 ± 10° for 5 secs.
Component mounted to
substrate a force of 5N
applied normal to the line
joining the termination
and in a line parallel to the
substrate.
- 55 to 125°C, 5 cycles
(1B, 2C1)
- 25 to +85°, 5 cycles
(2F4)
Requirement
25% Max leaching on each
edge
No visible damage
No visible damage. After
recovery
Δ C/C ≤±1% COG
or pF
Δ C/C ≤±10% X7R
Δ C/C ≤±10% X5R
Δ C/C ≤±20% Y5V
Tan
≤1.5 x speci-
fied value
IR.
≤0.25 x speci-
fied value
17
Fax: [phone] www.dubilier.co.uk Tel: [phone]