English
Language : 

Z3SMC1 Datasheet, PDF (1/2 Pages) Diotec Semiconductor – Surface mount Silicon-Zener Diodes (non-planar technology)
Z3 SMC 1 … Z3 SMC 200 (3 W)
Surface mount Silicon-Zener Diodes
(non-planar technology)
Flächendiffundierte Si-Zener-Dioden
für die Oberflächenmontage
Dimensions / Maße in mm
Maximum power dissipation
3W
Maximale Verlustleistung
Nominal Z-voltage – Nominale Z-Spannung 1…200 V
Plastic case
Kunststoffgehäuse
~ SMC
~ DO-214AB
Weight approx. – Gewicht ca.
0.21 g
Plastic material has UL classification 94V-0
Gehäusematerial UL94V-0 klassifiziert
Standard packaging taped and reeled see page 18
Standard Lieferform gegurtet auf Rolle siehe Seite 18
Standard Zener voltage tolerance is graded to the international E 24 (~5%) standard.
Other voltage tolerances and higher Zener voltages on request.
Die Toleranz der Zener-Spannung ist in der Standard-Ausführung gestuft nach der
internationalen Reihe E 24 (~5%). Andere Toleranzen oder höhere Arbeitsspannungen auf
Anfrage.
Maximum ratings and Characteristics
Grenz- und Kennwerte
Power dissipation – Verlustleistung
Non repetitive peak power dissipation, t < 10 ms
Einmalige Impuls-Verlustleistung, t < 10 ms
TA = 50/C
TA = 25/C
Operating junction temperature – Sperrschichttemperatur
Storage temperature – Lagerungstemperatur
Thermal resistance junction to ambient air
Wärmewiderstand Sperrschicht – umgebende Luft
Ptot
PZSM
3.0 W 1)
60 W
Tj – 50…+150/C
TS – 50…+175/C
RthA < 33 K/W 1)
Thermal resistance junction to terminal
Wärmewiderstand Sperrschicht – Anschluß
RthT
< 10 K/W
Zener voltages see table on next page – Zener-Spannungen siehe Tabelle auf der nächsten Seite
1) Mounted on P.C. board with 50 mm2 copper pads at each terminal
Montage auf Leiterplatte mit 50 mm2 Kupferbelag (Lötpad) an jedem Anschluß
2) Tested with pulses – Gemessen mit Impulsen
3) The Z3SMB 1 is a diode operated in forward. Hence, the index of all parameters should be “F” instead of “Z”.
The cathode, indicated by a white band is to be connected to the negative pole.
Die Z3SMB 1 ist eine in Durchlaß betriebene Si-Diode. Daher ist bei allen Kenn- und Grenzwerten der Index
“F” anstatt “Z” zu setzten. Die mit weißem Balken gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
206
28.02.2002